Table of Contents
Advertisement
TV / AV Selector button
RECALL/COLOUR SYSTEM button
Programme Selector button
VOLUME - button
STEREO/MONO button
Programme DOWN button
BASS EXPANDER button
SOUND MODE button
(This button is not used)
Battery Installation of the Remote Control Transmitter
1. Open the battery cover.
2. Install two "AA" 1.5 volt batteries so that the "+" and "-"
" - " marks inside the unit.
3. Close the battery cover.
Note: Replace the batteries when the TV set is showing the following symptoms:
Operation is unsteady or erratic, sometimes the TV set does not work with transmitter.
Discharged batteries may leak and damage the unit. The normal life of batteries should be from
nine to ten months.
Power ON/OFF
To switch on or off the TV ;
Press the Mains ON/OFF button.
The power of the TV is turned on or off complete-
ly. If no picture appears but the Standby and
Power indicator illuminates, press the POWER
ON/OFF button of the remote control transmitter
as the TV set is in standby mode.
To set the TV to standby mode;
Press the POWER ON/OFF button.
During Standby mode the Standby and
Power indicator illuminates more brightly.
TV / AV
-/- -
-/- -
DIGIT button
SWAP
SWAP button
A
B
•
BASS
Remote Control Transmitter
TIMER button
Power ON/OFF button
TIMER
MUTE button
ALTERNATE button
P
P
Programme UP button
CH SCAN
CH
CHANNEL SCAN button
VOLUME + button
MENU
PICTURE MODE button
CH
PICTURE
MENU button
SOUND
S. SYS
SURROUND
SURROUND button
SOUND SYSTEM button
JXPSC
marks on the batteries match the "+" and
General Operation
To turn on the TV from the standby mode, press
any of the following button.
● POWER ON/OFF button of the remote control
transmitter.
● Programme UP/DOWN of the remote control
transmitter or the TV set.
● 1 to 9, 0 button on the remote control
transmitter.
Important !
Be sure to set the Mains ON/OFF switch to the off
position, if the power failure occurs while viewing.
5
Advertisement
Table of Contents
