Basic Network Settings; Dhcp Mode; Static Ip Mode; Pppoe Mode - TIPTEL 3210 User Manual

4. Press the Save soft key to save, or the Back soft key to cancel；
4.5.2.2.Disable an Account
1. Access Menu->Settings->Advanced setting->Account (password: admin).
2. Press Enter key to enter the account activation status area.
3. Select "Disable" in the account active status area.
4. Press the Save soft key to save or the Back soft key to cancel.

4.6.Basic Network Settings

Through the Basic Network setting, you can set the IP Phones to get the IP address by three
ways：DHCP, static IP and PPPoE.
PATH: Menu -> Settings -> Advanced Setting -> Network

4.6.1. DHCP Mode

1. In the Network Settings interface, Press the OK key on the phone keyboard or the Enter
soft key to enter LAN Port：
2. In the LAN Port interface, press the Up or Down key on the phone keyboard to select DHCP
(default is DHCP).
3. Press the Enter on the soft key or the OK key on the phone keyboard to enter the DHCP
switch interface, it will auto return to last interface after seconds.

4.6.2. Static IP Mode

4. In the LAN Port interface, press the Up or Down key on the phone keyboard to select Static
IP, then Press the OK key on the phone keyboard or the Enter soft key to enter Static IP
Setting interface and input IP address.
5. Press the Down key on the phone keyboard to enter the Subnet Mask of Static IP Setting
and input the subnet mask.
6. Input the IP address, Subnet mask, Gateway, DNS 1 and DNS 2 in the corresponding area,
press the OK key on the phone keyboard or the Save soft key to save.

4.6.3. PPPoE Mode

1. In the LAN Port interface, press the Up or Down key on the phone keyboard to select
PPPoE, then press the OK key on the phone keyboard or the Enter soft key to enter PPPoE
Setting interface.
2. Press the Up or Down key on the phone keyboard to enter User Name and Password:
3. In according areas input User Name, Password.
31