King Quest VQ4100 Owner's Manual page 11

6. Run coax from the antenna unit to the roof edge, then along edge to location where coax will
be fed into the vehicle. If installing an optional second receiver, run second coax to location
where it will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below).
7. Drill 3/4" hole through the roof and into the cabinet where receiver is stored. Feed coax down
through hole. Seal opening with roof compatible sealant so that it is completely waterproof
(inside and outside of the 3/4" hole). Repeat for second coax if present.
8. Inside vehicle, make connections 1-3 in order shown below.
IMPORTANT!
Place power injector in a convenient
and accessible location.
AUX coax connects directly to second receiver (see page 5).
Do not over tighten the coax connections.
Do not put sharp bends or kinks in the coax cable.
You can cut the coax to length but you must
terminate the coax with Snap-n-Seal Connectors.
IMPORTANT!
Roof hole(s) for wiring must be sealed
so they are completely waterproof.
Sealant must be roof compatible.
IMPORTANT!
Plug in power supply last.
Antenna begins scanning when
power supply is connected.
Page 9