Maximum Pressure Limitingscrew - Yardworks 060-3895-8 Instruction Manual

model number 060-3895-8 | contact us: 1.866.523.5218
Before operating the log splitter,
loosen the bleed
several rotations, until air is able
to enter and escape from the oil
tank smoothly. Airflow should be
detectable through hole in the bleed
screw when the log splitter is in use.
In order to avoid oil leaking from this
point, verify that the bleed screw
is tightened before moving the log
splitter.
MAXIMUM PRESSURE LIMITING
SCREW
The maximum pressure was set
before the log splitter left the
factory, and the maximum pressure
limiting screw is sealed with glue in
order to ensure that the log splitter
works under pressure that does not
exceed 5 tons. The pressure was
set by a qualified mechanic using
professional instruments.
Unauthorized resetting may cause
the hydraulic pump to fail to
generate enough splitting pressure,
or it may RESULT IN SERIOUS
INJURY AND/OR DAMAGE TO THE
LOG SPLITTER.
FAILURE TO LOOSEN THE BLEED SCREW WILL KEEP THE SEALED AIR
IN THE HYDRAULIC SYSTEM COMPRESSED AFTER DECOMPRESSION.
!
CONTINUOUS COMPRESSION AND DECOMPRESSION OF THE AIR
WILL BLOW OUT THE SEALS OF THE HYDRAULIC SYSTEM, AND WILL
CAUSE PERMANENT DAMAGE TO THE LOG SPLITTER.
!
DO NOT ADJUST THE MAXIMUM PRESSURE LIMITING SCREW.
screw by
5