Sanyo PLC-XF30 Service Manual page 39

SLOT-B
SCREWS-A
SLOT-B
SCREW-A
SLOT-C
Condenser-lens adjustment
SLOT-B
SCREWS-A
SLOT-C
Relay-lens adjustment
SCREWS-A
SCREW-A
-47-
Before Adjustment :
1. Remove the connector K8E and connector K8V, and
remove the flexible cables of LCD panels from the
assembly Main. And turn on the projector.
2. Insert light block sheet in front of the blue panel to block
the blue light so that yellow
jected.
3. If the shade appears on the screen, adjust in the follow-
ing procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen four screws-A.
3.
If it appears on the top or bottom.--->
If it appears on the left or right. ----->
--
Insert slot screwdriver into each slot, turn it and erase shade. --
4. Tighten the four screws-A to fix the condenser-lens unit.
Before Adjustment :
1. Remove the connector K8E and connector K8V, and
remove the flexible cables of LCD panels from the
assembly Main. And turn on the projector.
2. Insert light block sheet in front of the red panel to block
the red light so that cyan
(Green and Blue lights)
ed.
3. If the shade appears on the screen, adjust in the follow-
ing procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen four screws-A.
3.
If it appears on the top or bottom.--->
If it appears on the left or right. ----->
--
Insert slot screwdriver into each slot, turn it and erase shade. --
4. Tighten the four screws-A to fix the Relay-lens unit.
light is pro-
(Green and Red lights)
Use two slots-B.
Use slot-C.
light is project-
Use slot-B.
Use slot-C.