Table of Contents
Advertisement
12 CIRCUIT OPERATIONS
Note: The circuit diagram may be modified at any time with the development of new technology.
12.1. Telephone Line Interface and Pulse Dial Circuit
When the hook switch SW1 is ON (off-hook), the circuit is closed, and current is supplied to the base of Q2 via the diode bridge
D1 and Q2 is On → Q1 is ON (OFF-HOOK condition).
Q1 and Q2 are the dial pulse generating circuits, and are driven by the DIALER (IC1), when the DIALER Pin 11 of IC1 is LOW →
Q2 is OFF and Q1 is OFF. (break) If port Pin 11 is HIGH → Q2 is ON → Q1 is ON. (make)
12.2. Tone Dial Circuit
Function:
The tone dialing circuit consists of a DTMF (Dual Tone Multi Frequency) signal generator (outputted from Pin 12 of the IC1) for
tone dialing, and also a circuit for outputting the signal to line.
The DTMF circuit identifies inputs from the 12 keys (1,2,3,4,5,6,7,8,9,0,
is four low frequencies (Low group) and three high frequencies (High group).
Circuit Description:
When a dial key is pressed, a DTMF signal is output from Pin 12 of IC1 as an analog synthetic wave.
The signal flow to the line is as follows.
Pin 12 of IC1 → R37 → Q9 → Q3 → Q1 → Tel Line.
The DTMF signal is sent to the line via the following path. Q9 and Q3 is an amplifier which is used to output the signal to line.
Shown below is the signal flow used to output the DTMF signal from the handset as a monitor tone when a dial key is pressed.
Pin 12 of IC1 → R48 → C33 → Q7 → C18 → Handset Speaker.
The signal combination and frequency corresponding to each dial key is shown on next page.
Tone Frequencies
Low Group
High Group
H1
Low Group
L1
1
L2
4
L3
7
L4
Frequencies
L1
697 Hz ± 1.5%
L2
770 Hz ± 1.5%
L3
852 Hz ± 1.5%
L4
941 Hz ± 1.5%
KX-TS3MXB / KX-TS3MXF / KX-TS3MXP / KX-TS3MXR / KX-TS3MXW
and #) by means of a total of seven frequencies, that
H2
H3
2
3
5
6
8
9
0
#
High Group
Frequencies
H1
1209 Hz ± 1.5%
H2
1336 Hz ± 1.5%
H3
1477 Hz ± 1.5%
-----
11
-----
Hide quick links:
Advertisement
Table of Contents
