Formax FD 8714CC Cross Cut Operator's Manual

Safety Devices and Other Features
Formax 8000 Series Shredders are equipped with various safety features:
Automatic Reverse Rotation
When too much paper is inserted, the cutter stops operating and
automatically rotates in reverse to discharge the jammed paper. An
alarm sounds. Reduce the amount of paper and restart the operation.
Door Switch / Multimedia Bin Switch
If the door or the multimedia bin cover is open, the shredder will not
operate. Close the door or cover and press start to resume shredding.
Automatic Stop
When the waste bin is full of shredded material, the "FULL" light comes
on and the cutter stops operation. Open the door, remove the waste
bin and empty it. Replace the waste bin, close the door and continue
operation.
Automatic Power Shut-Off
• If the shredder operates continuously for more than 30 minutes, the
power is automatically shut off.
• If the motor is overloaded, the "STOP" LED will flash until it cools down. When the
flashing stops the shredder is ready to be used again.
Oil Indicator
The "MANUAL" LED will flash after every four (4) hours of operation as an indicator to
oil the shredder cutting blades. The LED will continue to flash until oiled. NOTE: the
shedder will still operate when the LED is flashing but at a decreased load capacity.
To oil: Spread shredder oil onto the cutters through the feed opening, and allow the
oil to sit for a few minutes to permeate the cutting blades, then press the "REV" button
and hold for five seconds. "MANUAL" and "REV" LED indicators on control panel will
light. The shredder will operate in reverse for one minute, then the "AUTO" LED will light
indicating the shredder is ready.
Maintenance
• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use
a neutral detergent, then wipe again with a soft cloth.
CAUTION:
• Never put water directly on the surface of the shredder.
• Never clean the case with benzene or thinner, since it will cause discoloration.
• Do not dismantle the shredder. Contact your Formax Dealer for service.
FD 8714CC Cross-Cut
Multimedia Shredder
10/2013
OPERATOR MANUAL
FIRST EDITION