Advertisement
Installing the Liquid Crystal Display Module
To install the T1900's liquid crystal display module, follow the steps below and refer to Figure
4-34.
I.
Connect the two display cables to CNt and CNl on the LCD module.
2.
Place the module in the cover and route the cables so they will not be pinched by
the display panel or other components.
3.
Secure the panel with two Ml.Sx6 screws.
4.
Install the FL inverter board, display assembly, display mask, top cover, optional
PCMCIA card, optional memory card and battery pack as described in Sections
4.16,4.9,4.8,4.5,4,4,4.3 and 4.2.
4-41
Advertisement
