Operation - basic coatings Dirt Dragon Operator And Parts Manual

1. HANDLE ADjUSTMENT
A. Open the cam handle to release the handle locking gears.
B. Move the handle either up or down to a comfortable operating
height or the storage position.
C. Close the cam handle to lock the gears back into place.
2. MACHINE OPERATION
A. Fill the solution tank with clean water at a temperature not exceed-
ing 120°F. An operator can check the level of solution in the tank by
looking at the sight gauge on the side of the tank.
B. Add liquid detergent into the tank using the correct concentration
and manner specified by the manufacturer. Excess foam could
damage the vacuum motor, so be sure to use only the correct
amount of detergent.
C. Always use low foam detergent and defoaming liquid.
Defoaming liquid should only be used in the recovery tank,
never the solution tank.
D. Release the transport wheels by pressing on the foot lever. This will
lower the brush and squeegees onto the floor.
E. Plug the cord into a standard 120v outlet.
F. Turn on the Vacuum Switch
G. Turn on the Water Control Switch
H. Turn on the Brush Control Switch

OPERATION

H G
F
E
A
D
7