Adjustments And Replacement - basic coatings Dirt Dragon Operator And Parts Manual

1. BELT TENSION AND REPLACEMENT
A. Remove the solution tank and recovery tank.
B. Remove the solution control valve handle.
C. Remove all of the bolts holding the main shroud to the base.
D. Loosen the jam nut holding the belt tension bolt in place.
E. Turn the belt tension bolt in the desired direction to increase
or decrease belt tension.
F. Tighten the jam nut back in place on the tension plate.
G. Replace the main shroud back on the machine base and
tighten all of the bolts.
H. Replace solution control valve handle.
I. Replace the solution and recovery tanks.
2. HEAD PRESSURE ADjUSTMENT
A. To increase or decrease the brush pressure, loosen the jam
nut holding the head regulator bolt.
B. Turn the head regulator bolt counterclockwise to increase
head pressure or clockwise to decrease head pressure.
C. Once in the desired position, tighten the jam nut to hold the
regulator in place.
3. SqUEEGEE BLADE REPLACEMENT
A. Remove recovery tank from machine
B. Release tabs holding squeegee assemblies in place
C. Disconnect vacuum hose from squeegee assembly
D. Loosen the finger nuts from the squeegee assembly
E. Remove squeegee retainer from inside of the squeegee mount
F. The squeegee blades are easily removed from the squeegee
retainer.
G. Install new blades onto the squeegee retainer.
H. Insert the squeegee retainer back into the squeegee mount
I. Tighten finger nuts to hold the squeegee retainer in place.
J. Reinstall squeegee assembly into the machine.

ADjUSTMENTS AND REPLACEMENT

B
B
13