Advertisement
RX-7001PGD
Removing each board connected to the
rear side of the main board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1.
Cut off the tie band fixing the harness.
2.
Disconnect the harness from connector CN202 on
the video board.
3.
Disconnect the tuner board from connector CN101
on the main board.
4.
Disconnect the SEA board and the audio board from
connector CN452, CN301and CN302 on the main
board.
5.
Disconnect the V-audio board from connector CN303
on the main board.
6.
Disconnect the relay board 4.Then, disconnect the
video board and the S-video board from connector
CN201 and CN241 on the main board.
7.
Disconnect the DSP board from connector CN501
and CN601 on the main board while removing the
DSP board from the bracket fixing the lower part of
the DSP board at the same time.
8.
Disconnect the compulink board from connector
CN255 on the main board.
Bracket
CN201
CN241
Fig.9
1-4
(See Fig.5 to 9)
Compulink board
Main board
CN255
DSP board
Main board
CN601
Main board
CN501
Tie band
Main board
CN101
Tuner board
SEA board
Main board
CN452
CN302
CN452
CN301
Relay board 4
CN303 Main board
CN202
S-video board
Video board
V-audio board
Audio board
Fig.5
Audio board
Main board
CN302,CN301
Fig.6
V-audio board
Main board
CN303
Fig.7
S-video board
Video board
Main board
CN241
CN201
Fig.8
Fig.8
Fig.8
Advertisement
