Preparation - Bosch WTC84101GB Instruction Manual

Installation Technical data
– Delivery includes: dryer, installation and instruction manual.
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not install in a room which is susceptible to frost. Water may cause damage once it
starts to freeze.
– If in doubt, have the appliance connected by a specialist.
Setting up the dryer Remove all accessories from
1.
– The appliance plug must always be accessible. the drum. The drum must be
– Ensure that the appliance is installed on a clean, empty.
level and firm surface.
– Do not obstruct the air inlet on the front of the
dryer.
Consumption rates
– Keep the area around the dryer clean.
– Level the dryer using the front threaded feet.
On no account remove the threaded feet. Fabrics/programmes
Cottons 6 kg
. Cupboard Dry*
Do not install the dryer behind a door or a sliding
door which could obstruct the door of the dryer or
prevent it from being opened. Children can then Iron Dry*
not be trapped inside and their life endangered.
Clean and level
Make sure that the air
Easy-Care 3 kg
inlet remains unobstructed
. Cupboard Dry*
Mains connection For safety instructions, see page 11.
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
* Programme setting for testing in accordance with applicable standard EN61121.
– The mains voltage must be the same as the voltage specified on the rating plate
** The values may differ from those specified, depending on the type of fabric, composition of
( see page 9). laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
– The connected load and necessary fuse protection are specified on the rating plate.
Fabrics/programmes
Cottons 6 kg / 3 kg*
Do not operate the dryer if there
. Cupboard Dry***
Frost protection / Transport
is a danger of frost.
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.

Preparation

Optional accessories
Empty the container for condensation see page 4.
WTZ
11311
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
WMZ
20500
7 8
What to do if ...
Dimensions (DxWxH) 60 x 60 x 85 cm
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
service. We will always find an appropriate solution and will avoid unnecessary visits by
Weight approximately 35 kg
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
Max. capacity 6 kg carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by
Condensation container approx. 4.2 l
calling one of these numbers:
Ambient temperature 5 - 35 °C
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
Connection voltage 220 - 240 V
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
Connected load 2600 W
When contacting the after-sales service, please quote the appliance's product number (E no.)
Fuse protection 13 A
and production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
Product number
Rating plate or inside of the door
Production number
Start/Stop indicator lamp does
not light up.
You can find the rating plate on the back of the dryer.
The display panel light and
indicator lights (depending on
Residual moisture in the Drying time** Energy model) go out and the
fabrics after spinning consumption** Start/Stop indicator light
flashes.
13 A 13 A
Container empty / clean filter/air
1400 rpm (50%) 92 min 3.19 kWh
cooler indicator lights up.
1000 rpm (60%) 110 min 3.83 kWh
800 rpm (70%) 128 min 4.47 kWh Container empty / clean filter/air
cooler indicator light flashes.
1400 rpm (50%) 75 min 2.44 kWh
1000 rpm (60%) 90 min 2.93 kWh Dryer does not start.
800 rpm (70%) 105 min 3.42 kWh
800 rpm (40%) 44 min 1.27 kWh Programme terminated shortly
after the start.
600 rpm (50%) 55 min 1.59 kWh
Water is leaking out.
The door opens by itself.
Drying time Annual energy consumption
The required degree of dryness
was not achieved or the drying
time was too long.
85 min / per cycle 465 kWh / per year
(from after-sales service using order number)
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened on the washing machine with this connection set.
If the worktop of the washing machine is less than 544 mm deep, please consult the
Laundry damp.
after-sales service or your specialist retailer.
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry
the laundry. The humidity in the room has
increased significantly.
One or more indicator lights are
flashing.
Power failure.
9
Safety instructions
Emergency – Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the – in rooms inside the house.
dryer...
– use for drying fabrics.
The dryer must – be used for other purposes than those described above.
NEVER...
– be modified in terms of its technology or attributes.
Dangers – The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
Pay particular attention to cigarette lighters
Mains plug plugged in?
Programme selected? – Do not lean or sit on the door
Check the socket fuse.
– Open the door with care. Hot steam may escape.
Energy-saving mode is activated see the separate Installation – Fasten down loose leads risk of tripping.
Energy-saving mode instructions.
– Do not operate the dryer where there is a risk of frost.
Mains – Connect the dryer according to specifications to an AC earthed socket, as
connection otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
Empty container for condensation see page 4.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
Clean the fluff filter under running water see page 4.
– Do not use multiple plugs/couplings and/or extension cables.
Clean the air cooler, if required see page 6.
– Do not touch or hold the appliance plug with wet hands
Has the Start/Stop button been pressed?
shock.
Door closed?
– Never pull the appliance plug out of the socket by its cable.
Programme set?
– Do not damage the mains lead
Ambient temperature greater than 5 °C?
Operation – Only load the drum with items of laundry.
Check what has been loaded before switching the dryer on.
Make sure the dryer is level. – Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
Push the door closed until you hear it engage. cleaning solvent, etc.) fire/explosion hazard.
– Hazard due to dust (e.g. coal dust, flour):
Clean the fluff filter see page 4.
do not use the dryer risk of explosion.
Empty the container for condensation.
– Do not put laundry containing foamed material/rubber in the dryer
Ambient temperature higher than 35 °C ventilate the
material may be destroyed and the dryer may be damaged due to possible
room.
deformation of the foamed material.
Air inlet may be blocked clear obstruction.
– Switch off the dryer once the programme has ended.
Unsuitable programme selected? see page 7.
Dryer installed too closely to other objects? Provide – The water from condensation is not drinking water and may be contaminated
adequate air circulation. with fluff.
Mains failure Restart the dryer.
Defect – Do not use the dryer if it is defective or if you suspect that it is.
Fine layer of limescale on the moisture sensors. Clean the
Repairs must only be carried out by the after-sales service.
sensors see page 6.
– Do not use the dryer with a faulty mains cable. In order to avoid risk, have the
Use the next drying programme up or use the timed mains lead replaced only by our after-sales service.
programme as a supplement see page 7.
Spare parts – Only use genuine spare parts and accessories for safety reasons.
Warm laundry feels damper than it really is!
Disposal – Dryer: pull out the mains plug, then cut the mains cable from the appliance.
Make sure the room is sufficiently ventilated.
Dispose of the appliance at a public disposal facility.
Air inlet blocked? Clear obstruction.
– Packaging: Do not allow children access to items of packaging
Make sure that the air cooler is inserted.
risk of suffocation.
Clean the fluff filter and air cooler under running water – All materials are environmentally friendly and reusable. Dispose of in an
see page 4/6. environmentally responsible manner.
Check the installation conditions see page 8.
Switch off, allow to cool, switch back on and restart the
programme.
Remove the laundry from the dryer immediately and
spread it out. Heat may escape. 10
risk of explosion.
risk of tipping.
risk of electric
risk of electric shock.
elastic
Dryer
en Instruction manual
11