Preparation - Bosch WTE84106ZA Instruction Manual

Installation Technical data
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
1. Setting up the dryer Take all accessory parts
– The appliance plug must always be accessible. out of the drum.
– Ensure that the appliance is installed on a clean, level The drum must be empty.
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean. Consumption values table
– Make the dryer level using the threaded feet
and a spirit level.
Programme
Do not remove the threaded feet under any
circumstances.
Cottons
Cupboard dry*
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in. Clean and level Iron dry*
Make sure that the air
inlet remains unobstructed
Easy-Care
Mains connection
2. see safety instructions Page 11. Cupboard dry*
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate ( Page 9) must correspond.
* Programme setting for testing in accordance with the applicable IEC61121 standard.
– The connected load and necessary fuse protection are specified on the rating plate. ** The values may differ from those specified, depending on the type of fabric, composition of laundry to be dried, residual moisture in the fabric,
the degree of dryness that has been set, the amount of laundry being loaded and the environmental conditions.
3. Converting the installed load Note the fuse protection of the socket.
10/16 Amps Optional accessories
WMZ
20500
WTZ
1 x to the press and hold selection set
turn to turn to
11310
Off right then turn 3 x to the right amperage Off
WTZ
10 A off
1110
Feedback (depending on model):
16 A flashes
Do not operate the dryer if
Frost protection / Transport
there is a danger of frost.

Preparation

1. Empty the condensate container page 4.
2. Select any programme using the programme selector.
3. Press the Start/Stop button condensation is pumped into the container.
4. Wait 5 min. and then empty the condensate container again.
5. Turn the programme selector to Off.
8
7
What to do if ...
Dimensions (DxWxH) 60 x 60 x 85 cm (height adjustable) If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales service. We will
always find an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
Weight approximately 45 kg
the manufacturer and rest assured that the repair will be carried out by trained service technicians using
Max. capacity 7 kg original spare parts. The contact details of your local after-sales service can be found in the enclosed after-
sales service directory.
Condensate container 4.2 l
When contacting the after-sales service, please quote the appliance's product number (E no.) and
Connection voltage
production number (FD) (see the inside of the door).
Connected load Set the programme selector to Off and remove the appliance plug from the socket.
Fuse protection
see appliance rating plate The Start/Stop indicator lamp does
Ambient temperature not light up.
The display panel light and indicator
Product number/
lights (depending on model) go out and
Production number
the Start/Stop indicator light flashes.
You can find the rating plate on the back of the dryer.
The Container and
Power consumption when switched off 0.10 W
indicator lights are flashing.
Power consumption when ready for use (left-on mode) 1.00 W
The Filter and
indicator lights are flashing.
Dryer does not start.
Spin speed which
is used for spinning Duration** Energy consumption**
the laundry
7 kg 3,5 kg 7 kg 3,5 kg
Water is running out.
10 A 16 A 10 A 16 A 10 A 16 A 10 A 16 A
1400 rpm 112 min 98 min 93 min 63 min 3.54 kWh 3.54 kWh 1.95 kWh 1.95 kWh The door opens by itself.
1000 rpm 131 min 115 min 100 min 70 min 4.13 kWh 4.13 kWh 2.27 kWh 2.27 kWh
Creasing.
800 rpm 150 min 133 min 116 min 86 min 4.72 kWh 4.72 kWh 2.79 kWh 2.79 kWh
1400 rpm 93 min 69 min 78 min 48 min 2.55 kWh 2.55 kWh 1.78 kWh 1.78 kWh
1000 rpm 111 min 82 min 87 min 57 min 3.22 kWh 3.22 kWh 2.23 kwh 2.23 kwh
Laundry is not dried correctly or is still
800 rpm 130 min 94 min 98 min 68 min 3.90 kWh 3.90 kWh 2.81 kwh 2.81 kwh
too damp.
3.5 kg 3.5 kg
800 rpm 48 min 42 min 1.35 kWh 1.35 kWh
600 rpm 60 min 51 min 1.65 kWh 1.65 kWh
(from after-sales service using order number, depending on model)
Platform
For easier loading and unloading. The basket contained in the drawer can be used to carry the laundry.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth to save space. The dryer must be fastened
to the washing machine using this connection set. With pull-out worktop: WTZ 11300
Drying time too long.
Connection fittings for condensation outlet
The condensation is conveyed directly via a hose.
The humidity in the room increases
significantly.
Power failure.
One or more indicator lights for
programme status are flashing.
9
Safety instructions
Emergency – Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use – in rooms inside the house.
the dryer... – to dry fabrics.
The dryer must – be used for other purposes than those described above.
NEVER... – be modified in terms of its technology or attributes.
Dangers – The dryer must not be used by children or persons who have not been
instructed in its use.
Mains plug plugged in? Programme selected?
– Do not leave children unsupervised near the dryer.
Check the socket fuse.
– Keep pets away from the dryer.
Energy-saving mode is activated see the separate Energy-
– Remove all objects from pockets. Make especially sure that cigarette lighters
saving mode instructions.
are removed as they constitute an
– Do not lean or sit on the door
Start/Stop Empty the condensate container.
Installation – Secure loose cables
If featured, check hose for condensation outlet.
– Do not operate the dryer if there is a risk of frost.
Clean the fluff filter and/or air cooler under running water
Start/Stop
Page 4/6. Mains – Connect the dryer according to specifications to an AC earthed socket, as
connection otherwise it cannot be guaranteed that the appliance is completely safe.
Start/Stop button selected? – The cable cross-section must be sufficient.
Door closed?
– Only use earth-leakage circuit breakers with the following symbol:
Ambient temperature greater than 5°C? The optimum ambient
temperature for drying is between 5 °C and 35 °C. – The appliance plug and socket must be compatible.
– Do not use multiple plugs/couplings and/or extension cables.
Align dryer horizontally.
– Do not hold the appliance plug with wet hands
Clean air cooler seal.
– Never pull the appliance plug out of the socket by its cable.
Push the door closed until you hear it engage. – Do not damage the mains lead
Laundry load exceeded? Operation – Only load the drum with laundry. Check the contents before you
Remove articles of clothing immediately after the end of switch the dryer on.
the programme, hang up and pull into shape. – Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Unsuitable programme selected Page 7. grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
After the end of the programme, warm laundry feels damper cleaning solvent, etc.)
than it actually is. Spread the laundry out and allow the heat to – The tumble dryer is not to be used if industrial chemicals have been used for
disperse. cleaning.
Finely adjust the dryness level – this extends the drying time but – Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
does not increase the temperature. Your laundry will become explosion hazard.
drier.
– Do not turn off the dryer until the drying process ends, unless the laundry will
Select a programme with a longer drying time or increase the
be removed quickly and spread out, so that the heat can dissipate.
drying level. This does not increase the temperature.
– Do not put laundry containing foamed material/rubber in the dryer
Select a time programme for extended drying of laundry that is
elastic material may be destroyed and the dryer may be damaged due to
still damp.
possible deformation of the foamed material.
If you have exceeded the maximum load for the programme, the
laundry may not be dried correctly. – Light things, such as long hair, may be sucked into the air inlet of the dryer
Clean the moisture sensor in the drum. A fine layer of limescale Risk of injury.
may adversely affect the performance of the sensors and your – Final part of a tumble dryer cycle occurs without heat (cool down cycle), to
washing will not dry properly.
ensure that the items are left at a temperature that ensures that the items will
Drying has been interrupted as a result of a power cut, because
not be damaged.
the condensate container is full or because the maximum drying
– Switch off the dryer once the programme has ended.
time has been exceeded.
– The exterior of the appliance's rear panel becomes very hot during
Rinse the fluff filters under running water Page 4.
operation. Never touch the hot surface of the appliance's rear panel.
Insufficient supply of air ensure that air can circulate.
Keep children away from the appliance
Air inlet possibly blocked Clear inlet Page 8.
– Condensation is not drinking water and may be contaminated with fluff.
Ambient temperature higher than 35 °C ventilate the room.
The optimum ambient temperature for drying is between 5 °C Defect – Do not use the dryer if it is defective or if you suspect it is.
and 35 °C. Outside of this range, the drying time may increase.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger, only have
Make sure the room is sufficiently ventilated.
the defective mains cable replaced by the after-sales service.
– Always pull the mains plug out of the socket before changing the bulb for
Remove laundry from the dryer immediately and spread out. This
the interior light
allows the heat to dissipate. Be careful as the door, the drum and
the laundry may be hot.
Spare parts – Only use genuine spare parts and accessories for safety reasons.
Clean filter and air cooler Page 4/6. – Dryer: pull out the appliance plug, then cut off the mains cable from
Disposal
Check installation conditions
Page 8.
the appliance. Dispose of at municipal waste disposal facility.
Switch off, leave to cool down, switch on again, restart
– Packaging: do not leave children alone with packing parts
programme.
risk of suffocation.
– All materials are environmentally sound and can be reused.
Dispose of in an environmentally-responsible manner.
10
explosion hazard.
risk of tipping.
tripping hazard.
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
Dryer
WTE84106ZA
Risk of burns.
risk of electric shock.
en Instruction manual
11