Table of Contents
Advertisement
Installation
– Delivery includes: dryer, installation and instruction manual.
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not install in a room which is susceptible to frost. Water may cause damage once it
starts to freeze.
– If in doubt, have the appliance connected by a specialist.
Setting up the dryer
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean,
level and firm surface.
– Do not obstruct the air inlet on the front of the
dryer.
– Keep the area around the dryer clean.
– Level the dryer using the front threaded feet.
On no account remove the threaded feet.
Do not install the dryer behind a door or a sliding
door which could obstruct the door of the dryer or
prevent it from being opened. Children can then
not be trapped inside and their life endangered.
Mains connection
For safety instructions,
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage must be the same as the voltage specified on the rating plate
(
see page 9).
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection / Transport
Preparation
Empty the container for condensation
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
7
Remove all accessories from
the drum. The drum must be
empty.
Clean and level
Make sure that the air
inlet remains unobstructed
see page 11.
Do not operate the dryer if there
is a danger of frost.
see page 4.
8
Advertisement
Table of Contents
