Table of Contents
Advertisement
Advertisement
Table of Contents
Troubleshooting
Related Manuals for LOHBERGER Varioline LCP
Summary of Contents for LOHBERGER Varioline LCP
- Page 1 Varioline LCP Kitchen stove with pellet burner User manUaL Made in...
-
Page 2: Table Of Contents
Table of contents 1. Foreword ..................3 24. Remote maintenance / Network connection .......16 Appliance /SW Version 2. Our contribution towards climate protection ........3 Operating hours 3. Safety instructions ................3 25. Menu overview ................17 During installation and operation 26. -
Page 3: Foreword
1. Foreword With this solid fuel-fired stove you have selected a high-quality product made by LOHBERGER. Apart from the beautiful and timeless design we attach great importance to a fully developed combustion technique, high-quality materials as well as perfect workmanship. -
Page 4: Important Instructions
4. Important instructions Before connecting the appliance to the chimney, inform the local qualified chimney sweep. Please read the information in this manual carefully before you install or start up your appliance for the first time. Failure to do so causes the warranty to become null and void! Keep this operating manual in a safe place. -
Page 5: Only Install Original Spare Parts
Only install original spare parts Original spare parts provided by your local specialist dealer. Parts that are subject to wear and tear (e.g. seals), components exposed to high thermal stress (fireclay, cast-iron parts) or broken stove parts should be replaced or exchanged as soon as possible. The chimney may be clogged. -
Page 6: Description Of The Appliance
8. Description of the appliance 11 10 Stove bar Heating door handle 38 Main plate Stove frame Heating door glass (special version) 40 Grate Cooking plate Slide: grate shaker Ball latch Cover Roasting oven door complete 42 Base panel lateral (removeable) Control panel Roasting oven door handle 43 Ash pan... -
Page 7: Heating Damper
12. Heating damper To facilitate initial heating, all LOHBERGER stoves are equipped with a heating damper. Open- ing the damper opens a direct route from the fire chamber to the chimney. Consequently the closed flue gases need not take the “long” route through the roasting oven, but enter the chimney while still hot, in this way establishing a chimney draught very rapidly. -
Page 8: Roasting Oven Thermometer
14. Roasting oven All roasting ovens are equipped with baking sheet and grid, the lateral baking sheet carriers have 4 slide-in levels. The roasting oven inside is fully enamelled and therefore easy to clean. (Cleaning instructions on Page 18). The hot airflow gently circulates in the roasting oven. The convoluted route of the flue gas ducting guarantees even temperature distribu- tion on the stove plate (steel or CERAN®) and in the roasting oven, likewise the continuous heat radiation to the surroundings. -
Page 9: Switching The Appliance On/Off
Display ‘Operating state’ Graphic display of ‚Operating mode‘ burner OFF Display ‚Summer/Winter‘ Firewood = Operation with firewood burner ON Switch to summer is on burner activation blank Winter mode Firewood+Flame = Monitoring of firewood trial run firewood operation Display ‚NETWORK CONNECTION‘ burner shutdown Flame = Operation with pellets Red symbol: Connection fault... -
Page 10: Basic Operation
17. Basic operation To switch from the Home screen to the Menu level, press the Menu button (Fig. 6). burner OFF To display further menu items, press the button UP or DOWN (Fig. 7). To switch to the appropriate sub-menu, select the desired menu item (Fig. 7). Fig. -
Page 11: Ventilating The Chimney
18. Ventilating the chimney Ventilating the appliance or the chimney before operating with firewood The induced draught fan switches on, the change-over damper changes over to main menu pellet operation. After approx. 2 minutes the blower switches off automatically. chimney venting settings Select the main menu chimney venting (Fig. -
Page 12: Settings
20. Settings Settings on the appliance are adjusted in the menu Settings. To do so, select the menu Settings in the main menu (Fig. 15). The following menu items are avail- main menu able: chimney venting − language settings − time/date informations default settings −... -
Page 13: Heating Period
Heating period settings When operating with ‘Automatic mode’ you can determine heating times during language which the appliance heats in accordance with the preset boiler set-point tempera- time/date ture. There are 6 time programmes altogether to choose from. automatic mode auto heating period 1. -
Page 14: Information Menu
Reset settings To reset the customer parameters to factory setting, you can carry out a reset. keylock 1. Select Settings --> Reset in the main menu (Fig. 30). service code 2. Select OK to confirm the entry (Fig. 31). reset summer/winter winter HINWEIS: In a reset all CUSTOMER SPECIFIC SETTINGS such as heating times etc. -
Page 15: Sensors
Sensors information To access the sensor values, proceed as follows: sensors 1. Select Information --> Sensors in the main menu (Fig. 37). actuator system/SW version T buffer operating hours If a storage tank sensor is connected to the main board (X 12 / 3+4) for the inte- grated function of the differential temperature controller, the current temperature Fig. -
Page 16: Default Settings
Appliance /SW Version information The menu item system/SW version displays the set appliance type or the current sensors software version. actuator 1. Select Information menu --> system/SW version in the main menu (Fig. 43). system/SW version 2. Confirm the entry with OK (Fig. 44). operating hours Fig. -
Page 17: Menu Overview
24. Menu overview Schornstein entlüften Uhrzeit / Datum Automatikbetrieb Auto / Plus Heizzeiten Einstellungen Displaysperre Aus / Ein Servicecode 1234 Reset Sommer / Winter Sommer / Winter WLAN #### T Puffer Türkontakt Homescreen Rostkontakt Gerät ein / aus Hauptmenü ( Gerät ein / aus, Uhrzeit Freigabe Betriebszustand, Leistung, T Flamm... -
Page 18: First Start-Up
25. First start-up Do not leave small children unattended in the immediate vicinity of the appliance: the equipment is not childproof. Prior to the first start-up check all connections of the appliance (chimney flue connection, power supply, etc.). The viewing window and door become very hot when the stove is in use (temperatures up to 300°C). Make sure that these parts are not touched when the appliance is in operation. -
Page 19: Heating Operation With Pellets
27. Heating operation with pellets The regulation is determined by the specified boiler set-point temperature (75°C or 65°C, see setting SUMMER MODE /WINTER MODE). If the set-point temperature of the boiler is exceeded by 10°C, the appliance shuts down automatically display „Burner STOP“ - and only switches on again when the boiler temperature is 3 °C below the set-point. -
Page 20: Operation With Firewood
31. Operation with firewood Before starting the burner or operating the appliance with firewood, check the level in the reservoir. If the reservoir is full, the heat output to water cannot be dissipated or only be dissipated for a short time. This can lead to dis- turbances through the system constantly switching off in pellet operation and the thermal discharge safety valve may be triggered when the system runs on firewood During operation with firewood, there is no automatic control of the output through the pellet stove control. -
Page 21: Ignition Of Firewood Using The Pellet Burner
32. Ignition of firewood using the pellet burner It is also possible to ignite the firewood easily by means of the pellet burner: 1. Open the firebox door and place 3 – 4 small pieces of firewood (beech wood) burner OFF cross-wise on the grate (approx. -
Page 22: Summer /Winter Use
36. Summer /Winter use (Only for stoves with central heating insert) To reduce the water heating capacity for the summer operation (mainly cooking and baking), the device comes with a baffle plate. IMPORTANT! The heat output delivered to the hot water system will be reduced, however, it will not be stopped completely! Thus even for summer use make sure that excess hot water is discharged properly. -
Page 23: Maintenance / Cleaning
37. Maintenance / Cleaning CAUTION - RISK OF BURNS Allow the appliance to cool down before doing any cleaning work to avoid coming into contact with embers or hot compo- nents. CAUTION – Fire hazard The ash can still contain live embers: Dispose of the ash only into metal canisters! ATTENTION! risc of injury To avoid injury / damage to equipment disconnect the appliance from the electrical circuit before servicing! Regular maintenance and care or cleaning of the appliance, the fuel gas ducts and the chimney are particularly important for the opera-... -
Page 24: Cleaning Oven
Cleaning oven oven sensor Remove deposits from the appliance, in particular from the pellet burner block by means of the cleaning brush provided. Lift cooking plate and remove deposits from the interior of the stove . CAUTION! The oven sensor for the pellets module protrudes at the side from the oven protection (Fig. -
Page 25: Oven Door
Oven door To allow the oven to cool down, the oven door can be fixed at an angle of approximately 70°. The oven door can be completely removed. This is a real advantage when the oven is to be thoroughly cleaned. Removing the oven door •... -
Page 26: Cleaning The Glass Viewing Window Of The Combustion Chamber
Cleaning the glass viewing window of the combustion chamber To clean the glass viewing window use gentle cleaning agents (e.g. soapy water) and a soft cloth. In adverse weather conditions or as a result of incorrect operation or the use of unsuitable fuels the inside of the combustion chamber window may become fogged. For cleaning, please proceed as follows: •... -
Page 27: Stoves With Glass Ceramic Cooking Surfaces
Stoves with glass ceramic cooking surfaces What is CERAN® ? Glass ceramic cooking surfaces by the Mainz-based company SCHOTT (Germany) are extremely temperature-resistant and withstand even abrupt temperature shocks up to 750°C. CERAN® is insensitive to normal mechanical loads in the kitchen. The 4 mm thick glass ceramic also transmits heat very well. It allows radiated heat to pass with almost no loss, but hardly conducts any heat to the sides. -
Page 28: Troubleshooting
38. Troubleshooting The interaction of several factors is required for trouble free stove operation: Stove: correct installation connection and start-up. Operation and care: according to the information in the user manual, regular cleaning of stove, flue gas pipe and chimne. Chimney: correct dimensioning, perfect condition. -
Page 29: After-Sales Service
AUSTRIA (Head office) To enable our customer service to deal with repairs and supplying spare parts LOHBERGER Heiz u. Kochgeräte Technologie GmbH quickly and to your satisfaction, we require the following information with your Landstraße 19 service request. In this way you help us to save time and money and also to serve... -
Page 30: Troubleshooting - Operation With Pellets
40. Troubleshooting – Operation with pellets When an error occurs, a red box with the error message appears on the display. Remedy the fault according to the following list of faults and then acknowledge burner ON the error message. appliance cleaning Press the „OK“... -
Page 31: Resetting Safety Temperature Limiter
Display Identification of fault Cause Remedy / Solution Ignition program after power Power failure failure PLUG-IN TEMPERATURE Discharge chute sensor short Call service technician SENSOR KS circuit PLUG-IN TEMPERATURE Discharge chute faulty Call service technician SENSOR UB Heating door or start-up flap LOADING DOOR OPEN Close heating door or start-up flap open... -
Page 32: Technical Data
360 W / 50 W 43. Type test The Lohberger Pellet module was successfully tested by the Technical University of Vienna according to the current European Standards. Report testing institute no . PL-0418-P-E Emissions in accordance with Article 15a B-VG protection measures and energy savings are observed. -
Page 33: Dimensions
44. Dimensions 13,5 Ø 12 Ø 12 Ø 12 13,5 59,5 LCP 70 LCP 75 A LCP 75 B LCP 80 Code F1 + B1 F1 + B2 F2 + B1 F2 + B2 Width 77,5 82,5 82,5 87,5 The height dimensions are for a standard oven height of 85 cm, with special heights of respective height difference is offset. Note for equipment fire protection unit: Overmeasure per fire protection unit is + 5 cm / + 7.5 cm (closed version)! -
Page 34: Warranty
These warranty conditions are valid in all European countries where LOHBERGER appliances are sold by local specialist dealers. War- ranty claims must always be directed to a local LOHBERGER specialist dealer or the dealer from whom you have bought the appliance. - Page 36 Lohber Lohber Lohbe Lohb Lohb LOHBERGER HEIZ + KOCHGERÄTE TECHNOLOGIE GMBH Lohb LOHBERGER HEIZ- U. KOCHGERÄTE TECHNOLOGIE GMBH Landstraße 19, A-5231 Schalchen Landstraße 19, A-5231 Schalchen Tel. +43 (0) 7742/5211-400 www.lohberger.com Tel. ++43/(0)7742/5211-0 made in Austria Fax +43 (0) 7742/58765-110 www.facebook.com/lohbergerAT...