Mounting The Synchronizer (Does Not Apply To Machines With Flange Motor); Fitting The Reel Stand - Pfaff 571 Instruction Manual

Installation and commissioning
8 Mounting the synchronizer
.01.06
8

Fitting the reel stand

.01.07
8 - 4
1
Fig. 8 - 06
Fig. 8 - 07
(does not apply to machines with flange motor)
● Attach position stop 2 (part no.
91-141 688-90) with two screws.
● Slide synchonizer 1 onto the shaft so that
position stop 2 is located in the groove of
synchronizer 1 (see arrow).
● Slightly tighten screws 3.
● Insert synchronizer plug into the coupling
3
socket of the control box.
● Adjust synchronizer 1, see Chapter
11.04.01 Adjusting the synchronizer
2
● Fit the reel stand as shown in Fig. 8-07.
● Afterwards insert the stand in the hole in
the table top and secure it with the nuts
provided.