DVD-S1200
b. Inch the tray frontward until convex phase and concave
phase mate.
Caution:
Make sure to mate convex phase and concave phase
properly, so that the gap between turntable and tray
becomes 5mm or less.
21
5. Traverse Block
1. Lift the traverse block while spreading the hook of the
mechanical chassis unit.
2. Disengage the tabs from the holes of the mechanical
chassis unit.
<Precautions in reassembling the traverse
block>
• Take the following precautions when reassembling the
traverse block.
1. Turn traverse gear on the traverse block to let trigger
lever turn rightward.
2. Bring cam gear lever to the lever adjusting position at
the end of mechanical chassis unit.
3. Put tabs A and B into slots A and B respectively.
Place tabs C into hooks to mount the traverse block on
mechanical chassis unit. (Slot A... Mechanical Chassis,
Slot B... Cam Gear)