CycleOps PowerTap SL Owner's Manual page 24

M M A A I I N N T T E E N N A A N N C C E E & & S S P P E E C C I I F F I I C C A A T T I I O O N N S S
F F r r e e e e h h u u b b
The grease in the freehub pawls should be replaced if it becomes contaminated with water.
Replace the seal at the same time, contact Saris Cycling Group for replacement parts. Saris
Cycling Group recommends the following types of grease to ensure proper functioning:
-Kluber Isoflex NB52 o
-Dupont Krytox GPL226
Warning: Failure to use the proper grease on the freehub pawls could result in engagement
problems.
F F r r e e e e h h u u b b r r e e p p l l a a c c e e m m e e n n t t
-Use 5mm hex wrench and 17mm bike wrench and remove both end nuts from the axle.
-Remove the axle
-Remove the freehub and spacers.
-Remove all old grease from the freehub ratchet ring.
-Install spacers per the illustration.
-Install axle.
-Apply 2 grams of high quality freehub grease to the ratchet ring.
-Grease the V seal and place it on the freehub and install onto shaft.
-Replace end nuts. Torque end nuts to 12 lbs-ft.
24