Transporting - Honda HRX537VYE Owner's Manual

GRASS BAG CLEANING AND REPLACEMENT
Grass Bag Cleaning
Wash the bag with a garden hose, and allow it to dry completely
before use; a wet bag will clog quickly.
Grass Bag Replacement
Replace a worn or damaged bag with a Honda replacement bag or its
equivalent.
Bag Removal
1. Unclip the plastic edges [1]
of the bag [2] from the
frame [3].
2. Remove the bag from the
frame.
Bag Installation
1. Insert the bag frame [3]
into the bag [2], as shown
above.
2. Clip the plastic edges [1] of
the bag onto the frame.
[2]
[3]
[1]
[1]

TRANSPORTING

Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the mower on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
Turn the fuel valve to the OFF position. This will prevent carburetor
flooding and reduce the possibility of fuel leakage.
Handlebar Folding
1. Remove the grass bag, if
so equipped. You can
place it on top of the
engine, with the bag
opening to the front.
2. Unlock the handlebar
adjust knobs [1], and
then swing the handlebar
[2] forward.
When folding the
handlebar, be careful to avoid kinking or pinching the control
cables.
Loading and Unloading
Position the mower so all four wheels are on the bed of the transport
vehicle. Tie the mower down with rope or straps, and block the
wheels. Keep the tie-down rope or straps away from the controls,
adjustment levers, cables, and the carburetor.
NOTICE
To prevent losing control of or damaging the mower, do not use the
drive system when going up or down a loading ramp.
To prevent damaging the drive system, do not engage the clutch
when the mower is rolling backwards.
1. Turn the fuel valve to the OFF position.
2. Use a suitable loading ramp. Adjust the loading ramp so that it is
inclined at an angle of less than 15°. If a loading ramp is not
available, two people should lift the mower on and off the transport
vehicle while keeping the mower level.
ENGLISH
OFF
[2]
15°
[1]
17