Table of Contents
Advertisement
1. Remove the battery cover [1] by depressing the tabs [2] located on
the sides and releasing the tab on top of the battery cover.
2. Disconnect the battery connector [3] by depressing the connector
tab [4] and pulling the battery connector from the harness
connector [5], which is located inside the battery case, above the
battery.
[3]
[1]
[2]
3. Connect the battery connector [3] to the charger [6] supplied with
the mower.
NOTICE
Do not attempt to charge the battery with any charger other than
the one supplied with the mower. Use of a charger other than the
one supplied may result in damage to the electrical system or fire.
[3]
4. Plug the charger into a standard household power outlet and let
the battery charge for 20 to 24 hours. The charger may become
slightly warm during charging. This is normal.
NOTICE
Do not charge the battery for more than 24 hours or the battery
may be damaged. Disconnect the battery charger from the battery
before storing the lawn mower.
5. After the battery has charged, disconnect the charger and
reconnect the battery connector to the harness connector.
6. Replace the battery cover. Do not operate without the battery
cover installed.
REPLACING THE FUSE (HZEA TYPE)
The electric starter circuit and battery are protected by a 40 ampere
fuse. If the fuse burns out, the electric starter will not operate. The
engine can be started manually if the fuse burns out.
1. Remove the battery cover by depressing the tabs located on the
sides and releasing the tab on top of the battery cover (page 16).
2. Locate the fuse case [1] above the battery.
3. Remove and inspect the fuse [2]. If it is burned out [3], install the
spare fuse [4] provided with the mower as shown.
[4]
[6]
[5]
NOTICE
Never use a fuse with a rating other than 40 amperes. Serious
damage to the electrical system or a fire can result.
[4]
[5]
If a frequent fuse failure occurs, it usually indicates a short circuit or
an overload in the electrical system. Take the mower to an authorized
Honda servicing dealer for repair.
TRANSPORTING/STORAGE
TRANSPORTING
Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the mower on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
Turn the fuel valve to the OFF position. This will prevent carburetor
flooding and reduce the possibility of fuel leakage.
Handlebar Folding
1. Remove the grass
bag. You can place it
on top of the engine,
with the bag opening
to the front.
2. Turn the handlebar
adjust knobs [1] 90°
into the unlock
position.
3. Fold handlebar [2]
over mower.
When folding the
handlebar, be careful to avoid kinking or pinching the control
cables.
ENGLISH
[1]
[3]
[2]
[1]
OFF
[2]
17
Advertisement
Table of Contents
