Retaining Serial Numbers; Restoring The Serial Number Of The System Unit - ThinkPad X230 Hardware Maintenance Manual

Hide thumbs Also See for X230:
Table of Contents

Advertisement

Notes:
• Ensure that you use the correct screw. It is recommended to use new screws for replacements.
• If you have a torque screwdriver, tighten all screws irmly to the torque speciied in the screw information
table for each step.
• Ensure that torque screw drivers are calibrated correctly following country speciications.

Retaining serial numbers

This section includes the following descriptions:
"Restoring the serial number of the system unit" on page 56
"Retaining the UUID" on page 57
"Reading or writing the ECA information" on page 57

Restoring the serial number of the system unit

When the computer was manufactured, the EEPROM on the system board was loaded with the serial
numbers of the system and all major components. These numbers need to remain the same throughout
the life of the computer.
If you replace the system board, you must restore the serial number of the system unit to its original value.
Before replacing the system board, save the original serial number by doing the following:
1. Install the LENOVO ThinkPad Hardware Maintenance Diskette Version 1.76 or later, and restart the
computer.
2. From the main menu, select 1. Set System Identiication.
3. Select 2. Read S/N data from EEPROM. The serial number of the system unit is listed as 20: Serial
number.
4. Write down that number.
Note: The serial number of the system unit also is written on the label attached to the bottom of the computer.
After you have replaced the system board, restore the serial number by doing the following:
1. Install the LENOVO ThinkPad Hardware Maintenance Diskette Version 1.76 or later and restart the
computer.
2. From the main menu, select 1. Set System Identiication.
3. Select 1. Add S/N data from EEPROM. Follow the instructions on the screen.
If the MTM and Product ID numbers differ from each other on the rear label, use what is shown for the
Product ID ield. See the following example:
MTM on rear label:
TTTT-CTO S/N SSSSSSS
Product ID on rear label:
TTTT-MMM (Use this number when setting Serial Number.)
56
Hardware Maintenance Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

X230i

Table of Contents