Removing Guide Frames - Smeg SAP306 Instructions For The User

10.6 Removing guide frames

Removing the guide frames makes it easier to clean the side parts of the oven, and
it also needs to be done whenever the automatic cleaning cycle is used (only
available on some models).
• To remove the guide frames, pull the frame towards the inside of the oven to
unhook it from its housing A, then slide it out of the seats at the back B.
• When cleaning is complete, repeat the above procedures in reverse order to put
the guide frames back in.
10.7 Pyrolysis: automatic oven cleaning
Pyrolysis is an automatic high-temperature cleaning procedure which causes
dirt to dissolve. Thanks to this process, it is possible to clean the inside of the
oven very easily.
During the first automatic cleaning cycle, unpleasant smells may occur due to
the normal evaporation of oily manufacturing substances. This is an absolutely
normal phenomenon which disappears after the first cleaning cycle.
Before starting the automatic cleaning cycle, make sure that the oven does not
contain any foods or large spills from previous cooking operations.
During the pyrolysis cycle, a door locking device makes it impossible to open
the door.
If the oven is installed under a hob, make sure that the burners or electric
hotplates on the hob remain switched off during the automatic cleaning cycle.
38
Instructions for the User
B
A
(on some models only)