Swift caravan Owner's Handbook Manual page 67

Fitted Equipment
correct day. Press PROGRAMME to display
the first setting.
Set time Set day
PM
12:00
MO
Setting 1 Setting 2
1 AM 2
6:30
20
MOTUWETHFR MOTUWETHFR
Last Setting
12 PM
10:30
16
RUN
SASU
REVIEWING THE EXISTING SETTINGS
AND PROGRAMME YOUR OWN
Now each press of the PROGRAMME button
shows, in, turn, the set times, (twelve with
the TP5), together with their associated
control temperatures. The time and/or
temperature of each setting may be altered
to your own requirements using the + and -
(time) and L and M (temperature) buttons.
64
LIMITS OF ADJUSTMENT FOR TIME
SETTINGS
Time setting 1 can be at any time of the day
or night, but would normally be in the
morning.
:
Each of the time settings 2 to 6 can be at
any time between the proceeding setting and
1.59am. Time settings 2 to 5 can be set later
than the next setting, but doing this changes
the next setting as well..... E.g.changing
AM
8:30
setting 2 in any of the above to 3.00pm
16
would also change setting 3 and 4 to
3.00pm.
This feature prevents times being set out of
sequence. If you wish to return to the pre-set
programme reset the unit as described
above.
EVERYDAY OPERATION
When all twelve time/temperature settings
have been checked and/or
altered, ensure the Programmable Room
Thermostat is in the RUN mode with the
colon blinking before sliding the cover shut.
MANUAL OVERRIDE
If you wish to temporarily
change the control
temperature from the
automatic setting, there is no need to re-
programme the thermostats; just press the
up or down button until the temperature you
want is displayed. An up or down arrow will
appear in the display to remind you that you
have over-ridden the programmed
temperature. The unit will revert to
programmed temperature at the start of the
next programmed event.
CONSTANT LOW TEMPERATURE
CONTROL
To set the thermostat to control at its low
setting (5°C to 16°C depending on model) for
24 hours a day press both t and u buttons at
the same time. The display will show the
blinking colon, the low setting and the
snowflake symbol. To return to the automatic
programme press the t and u buttons
together again.
BATTERY REPLACEMENT
When the batteries
approach the end of their
life, a battery symbol blinks
in the display. Have the new batteries
unwrapped and ready, slide the battery cover
fully off to the left, remove the old batteries
and insert the new ones WITHIN ONE
MINUTE.
AM
6:30
19
MO
AM
12:00
16
MO