Swift caravan Owner's Handbook Manual page 57

Fitted Equipment
Automatic Ignitor
Prior to first ignition, make sure that the
batteries have been inserted; observe
correct fit battery cassette (see changing
batteries, page 57).
Thermostat
Set the required room temperature at the
control knob (numbers 1-10). For an
average room temperature of approx. 22°C
we recommend setting:
3-5 Without the Trumavent Fan
(switched on)
4-8 With the Trumavent Fan
Switching Off
Set control knob to "0". If turning off for a
long period of time, close the quick-acting
valve in the gas supply line. Close valve of
gas cylinder.
Important Operating Notes
1. If the gas supply line is filled with air, it
may take up to a minute before the gas
becomes available for combustion.
During this time depress the control knob
and continuously operate the piezo
ignitor until the flame ignites.
2. You will have to find out the exact
thermostat setting yourself, depending on
how much heat you need.
54
3. Repairs are only to be carried out by a
competent service engineer.
Attention: A new O-ring must always
be installed after dismantling the
exhaust duct.
4. Any alteration to the appliance (including
exhaust duct and cowl) or the use of
spare parts and accessories, which are
important to the function of the heater
and which are not original Truma parts, as
well as the non-observance of the
installation and operating instructions, will
lead to the cancelling of the guarantee
and exclusion of liability claim.
5. During the initial operation of a brand new
appliance, a certain amount of fumes and
a slight smell may be noticed for a short
while. Remedial action is to immediately
run the heater at maximum output and to
ensure adequate room ventilation.
6. In winter, before switching on the heater,
remove all snow from the cowl.
7. Inspect the exhaust duct and all
connections at regular intervals and
always whenever there is a blowback
(misfire). It is essential that the exhaust
duct is installed so that it slopes upwards
over its whole length and is securely fixed
with several clamps. Never place any
object on the exhaust duct, since this
could result in damage. The exhaust
duct connection to both the heater and
the cowl must be firm and well sealed.
Do not operate heaters with incorrectly
fitted or damaged exhaust ducts.
8. Never allow the warm air outlet on the
heater to be obstructed in any way. For
instance never hang washing on or in
front of the heater to dry. Misusing your
heater in this way could cause serious
damage from overheating. Do not place
flammable objects near the heater.
Please follow these guidelines in the
interest of your own safety.
9. If the burner makes an unusual noise or if
the flame lifts off while burning, it is likely
that the regulator is faulty and it is
essential to have it checked.
10.Cleaning (with switched off appliance): It
is recommended that at least once a year,
before the heating season starts, you
remove any dust that has collected on
the heat exchanger base plate.
Technical Data:
Type of gas: Liquid gas
(propane/butane)
Operating pressure: 30mbar (28mbar
butane, 37mbar
propane)
Rated thermal output: 3400W
Gas consumption: 30-280 g/h