Whale 'Elite' Microswitch Taps - Swift caravan Owner's Handbook Manual

Services
WINTERISING
To avoid damage as a result of freezing,
drain the entire water system. To protect
Elegance Tap or Shower units, the tap
control(s) and the shower handset on/off
control should be opened when draining the
system to enable stored water in the outlet
to drain back through the control valves and
out of the system (switch off pump at
isolator). Ensure that both the hot and cold
systems are fully drained, the cold drain plug
is a separate drain plug from the heater drain
plug. Tap spouts and shower heads should
be unscrewed, removed and stored in a dry
place. Please consult your dealer if in
difficulty. If they are unable to solve the
problem, contact Whale Customer Services
on 01247 270531 ext. 211 or 213.
WHALE 'ELITE' MICROSWITCH
TAPS
The micro switch taps are used when the
water supply is not pressurised.
When the tap is turned on the micro switch
(which is fitted inside the tap) activates the
pump to supply water.
Operation
Swivel the tap spout (a) to the desired
position over the sink, lift the control lever (b)
to activate the pump and allow water to flow
simultaneously. To adjust the temperature
28
swivel the lever (c) to the left or right as
shown below.
Cleaning
It is recommended that a non-abrasive damp
cloth is used for cleaning the Elite
Tap/Shower.
Microswitch Replacement: A microswitch
replacement kit is available (ref. MT8000).
Note: Before commencing microswitch
replacement ensure instructions are read
through thoroughly. The entire process can
be completed without the need to remove
the tap from the worktop.
Before you Start
1. Ensure pump is isolated.
2. Position lever in central, i.e. mixer, off
location.
Important
Note position of
ACTUATOR before
removing it.
Microswitch Replacement
1. Carefully remove lever cap. A recess at
the back of the lever cap is provided to
assist with this.
2. Remove screw with No. 2 Pozi
screwdriver. Note the position of the lever
at this stage.
3. Lift off the lever.