Follow the steps in this guide to set up your kit. If you need some help, see the Frequently Asked Questions at bt.com/producthelp or call 0808 100 6116*. * Calls made from within the UK mainland network are free. Mobile and International call costs may vary.
Page 2
Plug one end of the ethernet cable into a port on your router/hub. Use the GigE port if your router has one (it’s port 4 if you have a BT Hub 3). Plug the other end into the base station Router port. The Router light will glow green.
Page 3
Connect your device to base station Wi-Fi Settings Wi-Fi Settings To connect dongle using WPS Press the WPS button on your dongle. Press the WPS button on the base station within 2 minutes. Wi-Fi Settings Wi-Fi Settings Wait until the WPS light stops flashing. Your computer and dongle are now connected to the base station and ready to use.
To connect dongle to another wireless network manually Note: If your device already has built-in wireless, you may want to switch it off to make sure you’re connecting with your new dongle. Click in your system tray (lower-right corner of your screen) to view available wireless connections.
In the Device Manager Network Adapters, if you can find BT Wi-Fi Dongle, the driver is installed successfully. If the driver BT Wi-Fi Dongle is displayed with ‘!’, ‘?’, ‘X’ symbols, the driver installation has failed. In this case, you’ll need to update or reinstall the driver again. Right-click on BT Wi-Fi Dongle, and then click Update Driver and follow the instructions on the screen.