Advertisement
1
Connect your base station
The base station adds 5Ghz wireless to your existing network. Make sure your
hub/router is up and working and place the base station next to it.
Connect the power supply to the base station. The Power light will glow green. If not,
1
check the On/Off switch on the back.
Plug one end of the ethernet cable into a port on your router/hub. Use the GigE port
2
if your router has one (it's port 4 if you have a BT Hub 3). Plug the other end into the
base station Router port. The Router light will glow green.
1
2
Set-up your dongle
See 'Connection help' if you don't have a CD drive on your computer.
IMPORTANT: Do NOT plug the dongle in until you've installed the drivers from the CD.
Insert the CD into your CD-ROM drive and click Run Setup.exe to begin install drivers.
1
Follow the on-screen instructions until set-up is complete.
2
Plug your dongle into a USB port and click Finish. Give it a couple of minutes to
3
set itself up.
TIP: Using a company laptop? You might need administrator rights.
(The driver install procedure in different
operating systems is quite similar.
This example uses Windows 7).
2
Advertisement
