Table of Contents
Advertisement
IMPORTANT: Only qualified Personnel should service internal components or electrical wiring.
Should your unit fail to operate properly, check that there is power to the unit and that the hopper con-
tains ice. If the unit does not dispense, check the following chart under the appropriate symptoms to
aid in locating the defect.
Trouble
BLOWN FUSE OR CIRCUIT BREAKER.
AGITATOR DOES NOT TURN, AUGER DOES NOT
TURN.
ICE DISPENSES CONTINUOUSLY.
SLUSHY ICE. WATER IN HOPPER.
AGITATOR TURNS, AUGER DOES NOT TURN.
AUGER TURNS, AGITATOR DOES NOT.
TROUBLESHOOTING
A.
B.
C.
D.
A.
B.
C.
D.
E.
F.
A.
B.
C.
D.
A.
B.
C.
D.
A.
B.
C.
D.
E.
A.
B.
C.
15
Probable Cause
Short circuit in wiring.
Defective 24 VAC transformer..
Defective agitator motor.
Shorted motor.
No power.
Bent depressor plate (does not actuate switch).
Defective dispensing switch.
Defective interlocks, lids not closed.
Defective timer board
Defective 24 VAC transformer.
Stuck or bent depressor plate (does not
release switch).
Defective dispensing switch.
Improper switch installation.
Defective timer board.
Blocked drain.
Unit not level.
Poor ice quality due to water quality or
icemaker problems.
Improper use of flaked ice.
Defective auger motor.
Defective or improper setting of speed control.
Defective rectifier.
Ice jam.
Defective timer board.
Defective agitator motor.
Defective motor capacitor.
Defective timer board.
620917311
Advertisement
Table of Contents
