Page 1
T7470 Paging System Transmitter U S E R M A N U A L Long Range Systems, LLC 4550 Excel Parkway, Suite 200 Addison, TX 75001 800.437.4996 214.553.5308 • lrsus.com...
Connections The following diagram shows the system connections. NETWORK/ETHERNET CABLE 110/220V ELECTRICAL SUPPLY (Optional) 12 VDC POWER ADAPTER CONDOR LISTED ANTENNA 34 pm #: ------ Staff KEYPAD/TRANSMITTER SETUP CALL PHONE PROMO MODE CLEAR ENTER WWW.LRSUS.COM Long Range Systems T7470 User Manual...
1. After the transmitter initializes, the set date menu is shown, type in the current date (Using MM/DD/YY) and press ENTER. 2. When the display asks to enter time, type in the current time and select F1 (AM) or F2 (PM). Long Range Systems T7470 User Manual...
5. Press F1 (V1), F2 (V2) or F3 (V3) for 1, 2 or 3 vibrations. ll Call Page: Page all guest pagers simultaneously. At (Guest #: - - -) Screen Display: 1. Enter 000 then press ENTER. Long Range Systems T7470 User Manual...
Canned or Special lphanumeric Messages Using Message Codes When prompted for a message on the T7470 Transmitter (T7470): 1. Enter message number code (and an extension number – optional). 2. Press ENTER. Example: Send a message to call extension 123.
Food Officer Station Dock Service Buffet Machine You have mail Seat Diaper change Operator Child crying Table ready Booth Emergency To nursery No special Lobby XX Minutes Hole Help Kitchen Restroom Pro Shop Valet Long Range Systems T7470 User Manual...
4. Press F1 (YES) to turn theft mode on (Press F2 (NO) to turn off). 5. Main screen display will show “T “ on upper left corner when turned on. Note: nti-Theft does not work with the RX-SP4. When nti-Theft is enabled, Repeat Delay is Disabled. Long Range Systems T7470 User Manual...
The Duration is the total amount of time the repeated pages will continue for in seconds. For example, if you choose 120 seconds, the T7470 Transmitter will continue to page at the predefined in- terval until the overall 2 minutes (120 seconds) is timed out.
• Pagers must be programmed in the group mode. • Staff pagers must be numbered above 100. (1-99 are reserved for groups) • Any alphanumeric pager can be a member of up to 5 groups. Long Range Systems T7470 User Manual...
Dry Contacts The Dry Contact are contacts or switches that are connected through a wire to the T7470, for example: Doorbell. This sensor can send a message to the pager or cell phone when an event occurs (e.g., alarms if a door is opened).
11. Press F4 to EXIT. T7470 Dry Contact Specifications: Input Voltage 0-5 Volts DC Contact Diameter 2.5 mm Contact Type Mono Plug T7470 Dry Contact Cable Specifications: Contact Diameter 2.5 mm Contact Type Mono Plug Number of Conductors Ring Connection Positive...
Page 15
6. At Set pager Number menu, either: • Enter the number of the pager to be alarmed followed by ENTER. • Press F1 (KEEP) to use the existing number. Note: Entering pager number 911 will page all lpha pagers. Long Range Systems T7470 User Manual...
F3 (EDIT) to change it. Enter the desired message using the number keys, waiting until the cur- sor moves between letters (i.e. for letter ‘E’ press #2 twice). Similar to a Cell Phone. 6. Press the ENTER key to save your message. Long Range Systems T7470 User Manual...
Setting Time and Date for T7470 Transmitter Set Date: 1. Press SETUP and press 1) System enter Password. 2. Press 3) Date/Time. 3. Press 3) Set Date. 4. Enter Date (MM/DD/YY) (e.g. March 11, 2010 = 03/11/10) and press ENTER.
1. Press SETUP and enter Password. 2. Press 1 (System). 3. Press F2 (DN) until screen show 1 (POCSAG). 4. Press 1 (POCSAG). 5. Press F2 (DN) until screen displays 3 (Vibe Strength). 6. Press 3 (Vibe Strength). Long Range Systems T7470 User Manual...
Note: See pg. 16 for Creating lphanumeric Messages. Display the Guest and Staff Prompt When paging Guest or Staff Alpha Pagers, the user is shown a prompt: T7470 Transmitter screen Display Select Page Mode MSG: 035 - - - -...
Page 21
3. Press F2 (DN) until screen shows 1 (POCSAG). 4. Press 1 (POCSAG). 5. Press F2 (DN) until screen shows 1 (Msg Editing). 6. Press 1 (Msg Editing). 7. Select Guest or Staff 8. Press F2 (Down) 9. Press 1) Freeform Long Range Systems T7470 User Manual...
7. Press a number to use (0 – 9) to change the default Station ID number and press ENTER. djust Transmit Power The range may be increased or decreased from the transmitter by adjusting the transmit power level. The Long Range Systems T7470 User Manual...
• Pagers will Beep or Flash until returned to charging unit or batteries removed. To activate 1. Press SETUP and enter Password. 2. Press 3 (OTHER). 3. Choose 3 (Locate Pagers). 4. Press ENTER to begin locating pagers. Long Range Systems T7470 User Manual...
System Requirements Cell Phone Paging requires broadband internet service, a CAT-5 Ethernet cable, and a contract with Long Range Systems. If you would like to utilize cell phone messaging, please contact your local LRS office or call 800.437.4996. Two Steps to enable the Cell Phone Paging: Step 1 1.
5. Press 1 for SMS Text or 2 for Voice Message. Note: Long Range Systems must setup the SMS Text or Voice Message before this feature can be used. If the user wishes to change the Message or type of message, contact Long Range Systems.
This procedure is repeated for each pager being programmed. Two charging bases are suggested for pro- gramming Alpha Coasters. Note: Guest lpha Pagers numbers must be above POCS G start. 1. Put all coasters to be programmed on one charger base, leave the second base empty. Long Range Systems T7470 User Manual...
Page 28
8. When the Vibration/Beeping Stops, press ENTER again. 9. The Pager will beep three times to indicate it is being programmed and the screen will display: Example: System ID = 0, Pager ID Number = 99, ll Page = 911 Long Range Systems T7470 User Manual...
8. The Pager will beep three times and additional beeps for each Group Number and Group Name assigned. Example: System ID = 0, Pager ID Number = 99, All Page = 911, Group = 1, 2 [Group numbers will display across the screen as you enter them] Long Range Systems T7470 User Manual...
• When it stops vibrating, press ENTER. • Screen will display “Transmitting Key”. • Pager will beep once and display “Pgr Encryption None”. 3 (3: Transmit Key) to send the current encryption key to pagers. • Follow instructions on display. Long Range Systems T7470 User Manual...
Note: The welcome message has a 32 character limit. 6. Turn off and then turn on Alpha Pager. 7. Press ENTER. 8. Pager should Beep Once to indicate programming. 9. Cycle power on Pager to view New Message. Long Range Systems T7470 User Manual...
Bits per second: 9600 Data bits: Parity: None Stop bits: Flow control: None Screen View of Typing ECHO 9. Type ECHO1 and press ENTER. (This echo function will allow you to see what is being typed.) Long Range Systems T7470 User Manual...
Example: To set an ID of 2, type RID,2 and press ENTER twice. Example Restaurant ID to 2 HyperTerminal Output Showing ID as 2 Type ST T and press ENTER Status View Showing Restaurant ID as 2 Long Range Systems T7470 User Manual...
Page 34
Example: To set a Power Setting of 3, type HWPR,3 and press ENTER twice.. Example High Power Set to 1 HyperTerminal Output Showing High Power Set to 1 Status View Showing High Power Set to 1 Long Range Systems T7470 User Manual...
Page 35
The default Baud Rate of Alpha Numeric Pagers is 1200. If the rate on the transmitter is changed, the rate of the Alpha Numeric Pagers will also need to be changed. Example of RF Baud to 2400 Status View Showing RF Baud to 2400 Long Range Systems T7470 User Manual...
• If the periodic TRANSMIT flash does not occur, move the repeater closer to the transmitter and try again. • Keep moving the repeater toward the transmitter until the TRANSMIT flash occurs. • After establishing the correct distance, mount the repeater as high as possible Long Range Systems T7470 User Manual...
Lifetime of Batteries: Approximately 3-5 years. (depending on usage). Battery Charge Life: Approximately 12 - 48 hours (depending on usage). Recharge Time: Typically 8 hours depending on usage (24 hours minimum from completely “dead”). Long Range Systems T7470 User Manual...
If pagers continue to not receive pages, contact LRS. My Cell Phone Paging Is Not Working 1. Do you have an account setup with Long Range Systems for a voice/SMS messaging service? If Yes, proceed to Step 2. 2. Check Network cable and make sure both ends are plugged in. Green Light will be lit, and the Or- ange Light should blink to indicate connectivity.
(800) 437-4996 or (214) 553-5308 (24/7 days a week) For weekend or night emergencies: • Long Range Systems has 24/7 live technical support available. • Please keep in mind that options are limited over the weekend. LRS Pagers vailable for the...
Page 40
Set Contrast 1. Using the UP (or DN) scroll button scroll until display shows “Set Contrast”. 2. Press Read/Select. 3. Use the UP (or DN) scroll button to adjust. 4. Press Read/Select to confirm. Long Range Systems T7470 User Manual...
Page 41
• Set Vibe strength - Strong or Weak and press Read/Select to set. • Set Alert Time (seconds) and press Read/Select to set. Battery The RX-E 4-Line Alphanumeric pager uses 1 AAA Battery. Programming To program the pager see pg. 29 Long Range Systems T7470 User Manual...
5. Replace the pager in the charger at the end of each day. Menus To access the vibe/contrast menu, remove the pager from the charger. While vibrating or beeping, press and hold the Select button for 8 seconds. This top-level menu will display: Long Range Systems T7470 User Manual...
Page 43
4. To exit, wait 8 seconds. And the pager will go back to the vibe/contrast menu. SP5 Pager Screen VIBE CONTRAST 5. To exit this menu wait 8 additional seconds. Long Range Systems T7470 User Manual...
3. Press the Select Button to continue scrolling forward through the message or messages. Time Pager will display the current time. The T7470 Transmitter automatically updates this feature. If the time does not appear, a flashing star will appear on the right side of LCD to show pager is operational.
3. Remove from charger, and pager will vibrate, beep, and light all lights as a verification that it is working. 4. Replace the pager in the charger at the end of each day. • The Alphanumeric Coasters use the Charger 8 (CH-R8). Programming To program the pager see pg. 27 Long Range Systems T7470 User Manual...
LRS Europe GmbH LRS Middle East Ltd LRS South frica LRS United Kingdom +49 531 310542 0 +9613 81 82 84 +27 21 422 4975 +44(0)1782 537000 www.lrs.eu.com www.lrs-lb.com www.lrssa.com www.lrspagers.co.uk Long Range Systems T7470 User Manual...
• Consult the dealer or an experienced radio/TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Long Range Systems T7470 User Manual...
These general terms and conditions (“General Terms and Conditions”) govern all persons (“Purchasers”) that purchase or license equipment, software, firmware, and/or services (collectively “Deliverables”) from Long Range Systems, LLC (“LRS”). Limited Software Use License. All software and firmware (collectively “Software”) is licensed for use only by Purchaser and, in the case of Software for paging receivers, by customers of Purchasers.
Page 50
If any action at law or in equity is necessary to enforce or interpret any of the rights or obligations of the parties to these General Terms and Conditions, the prevailing party shall be entitled to reasonable attorneys’ fees, costs, and necessary disbursements, in Long Range Systems T7470 User Manual...
Page 51
Conditions is terminated for any reason, all of the duties and obligations that the agreement and these General Terms and Conditions impose upon Purchaser shall continue in full force and effect, except any obligation to make payment for a Deliverable prior to its delivery. XU-0134 101714 Long Range Systems T7470 User Manual...