Table of Contents
Advertisement
AG-268 SIP Gateway User Manual
3． Restore to factory default
If your AG-268 settings is in chaos or you can't get the AG-268 IP to access it,
you can reset the device to factory default:
a) Power off
b) Press reset button and power on
c) The PWR led will light
Then the PWR and SYS led light.
d) Release the reset button after about 15~20 seconds,
e) The PWR, SYS, WAN and LAN led will blink for a while and then the PWR
and SYS led will light.
AG-268 will be reset to factory default after the above procedure, you can
then access AG-268 through its LAN port, please refer to
details.
Then PWR , SYS, WAN and LAN led will blink
access_AG268
for
32
Advertisement
Table of Contents
Need help?
Do you have a question about the AG-268 and is the answer not in the manual?