To Receive; Selecting A Channel; S-Meter - Cobra GR 29 LTD ST Operating Instructions Manual

Operation
Note
With the S/RF-SWR-CAL switch
in the SWR position the meter
needle should ideally be as far
to the left as possible.
While still holding down the microphone but -
Anything over 3 is not accept- 5
ton,set the S/RF SWR CAL switch to the SWR
able. A slight antenna height
position, to read the SWR reading.
adjustment (higher or lower)
may be required. Repeat rel-
Repeat the same steps 2 to 5 on Channel 1
6
calibration steps.
and 40. This will check SWR for all channels.

To Receive

To Receive
Rotate the
1
The green RX/TX LED will be illuminated.
12
On/Off Volume knob clockwise.

Selecting A Channel

Switch to NOR to select desired channel.
1

S-Meter

Swings proportionately to strength of incoming
signal when receiving.
1 The S/RF-SWR-CAL switch must be in the
S/RF position to read the meter.
Operation
Selecting A
Channel
Note
Switch to 9 or 19 for instant
access to these channels.
S-Meter
13