Operation
Calibrate for
SWR continued
Note
When switched to SWR
mode the meter reading
should ideally be as far to the
left as possible. Anything over
Release the PTT button, press and release the
5
3 is not acceptable. A slight
S/RF-SWR CAL button to the SWR position.
antenna height adjustment
Then press the PTT button to read the SWR
(higher or lower) may be
reading.
required. Repeat recalibration
Repeat the same steps two through five on
6
steps.
Channel 1 and 40. This will check SWR for all
channels.
To Receive
To Receive
Rotate the On/Off Volume knob clockwise.
1
The RX icon will be displayed.
12
Selecting A Channel
Unit should be in CB mode. Rotate channel
selector clockwide or counter-clockwise to
1
select desired channel.
S-Meter
Swings proportionately to strength of incoming
signal when receiving.
2
3
1.5
CAL
SWR
S/RF
RF
5 7 9
3
1
SIG
+30dB
VOL
SQ
DYNAMIKE
The S/RF-SWR-CAL switch must be in the S/RF
1
setting to read the meter.
Operation
Selecting A
Channel
S-Meter
RX
13