Advertisement
4. Then press the lock button on each remote to
pair them.
5. Remove key from ignition.
6. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
Use this Procedure for Vehicles with Driver
Information Center Buttons. This information is
in your Owners Manual in the Drivers Information
Center Section.
1. Insert Key and turn to ON position so you can
access Driver Information Center.
2. Press the vehicle information button until PRESS
TO RELEARN REMOTE KEY displays.
3. Press the set/reset button until REMOTE KEY
LEARNING ACTIVE will display.
4. Press and hold the LOCK and UNLOCK buttons
on the keyless remote at the same time for
approximatley 15 seconds. A chime will sound
indicating that the remote is PAIRED.
5. To PAIR additional remotes at this time repeat
Step #4. This vehicle can have a maximum of
eight remotes paired.
6. To exit PAIRING MODE turn key off and remove
key.
7. Test all remotes.
Use this Procedure for Vehicles with Driver
Information Center Buttons. To access this
display, the vehicle must be in Park (P) with key
in the on position (as far as you can go without
cranking engine).
1. Press the trip odometer reset stem until
RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for
three seconds.
3. The message REMOTE KEY LEARNING
ACTIVE will display.
4. Press and hold the LOCK and UNLOCK buttons
approximately 15 seconds. A chime will sound
PAIRING
24
indicating that the remote is PAIRED.
5. To program additional remotes at this time repeat
Step #4.
6. This vehicle can have a maximum of eight
remotes PAIRED.
7. To exit PAIRING MODE turn key off and remove
key.
8. Test all remotes.
33
Advertisement
