Advertisement
A. Close then open the driver's door.
B. Insert the key into ignition and
leave in ignition.
C. Close the driver's door.
D. Turn the ignition to ON
(Do NOT Start) then back to OFF.
E. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock
then unlock automatically indicating successful entry
into PAIRING MODE. Return to Step #1 if the locks
do not cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the LOCK and UNLOCK
buttons on the remote
simultaneously for 1 second.
B. Immediately after letting go of the
lock and unlock buttons press
the lock button by itself and hold
for 2 seconds.
7. Within 3 seconds, the door locks should
lock and then unlock once indicating
successful pairing.
8. If the door locks cycle twice, repeat steps A and B as
the remote was not accepted.
9. Repeat steps A and B in Step #6 for each
new remote.
10. Open driver's door.
11. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Start with key out of the ignition, driver's door is
open, all others are closed, and driver's door is
unlocked.
2. Insert key into ignition (Do NOT turn)
and pull it out.
3. Perform these steps within 40 seconds.
A. Using the power door lock switch on
driver's door, perform 5 LOCK/UNLOCK
cycles starting with lock.
Use an even pace and try to go about
one cycle per second.
(1 cycle = 1 LOCK and 1 UNLOCK)
B. Close, then open driver's door.
30
PAIRING
13
4. Perform these steps within 40 seconds.
A. Using the power door lock switch on
driver's door perform 5 LOCK/UNLOCK
cycles starting with lock. Use an even
pace and try to go about one
cycle per second.
(1 cycle = 1 LOCK and 1 UNLOCK)
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start)
then back to OFF.
D. Turn the ignition to ON (Do NOT Start)
then back to OFF.
E. Remove the key from the ignition.
5. Within 3 seconds the power door locks should
cycle automatically indicating successful entry into
PAIRING MODE. Return to Step #1 if the locks do
not cycle at this point.
Perform these steps within 40 seconds.
A. Press the LOCK and UNLOCK buttons
on the remote simultaneously for 1
second.
B. Immediately after letting go of the
LOCK and UNLOCK buttons, press
the LOCK button by itself and hold for
2 seconds. Within 3 seconds the door
locks should cycle once indicating
successful pairing. If the door
locks don't cycle or cycle twice, repeat
steps A and B, your remote has not
been accepted.
C. Repeat steps A and B in Step #6 for each
new remote.
6. Close driver's door.
7. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Turn ignition to run position (as far as you
can go without starting engine).
2. Using any working remote, press the
UNLOCK button for 4 to 10 seconds.
3.
continue pressing the UNLOCK button
and press the PANIC button for 1 second and
release both buttons at the same time.
14
Advertisement
