Advertisement
10.
LOCK and UNLOCK buttons on
the remote simultaneously until the door locks and
unlocks. This step may take up to 30 seconds.
11. Repeat Step #10 now for each additional remote
(including any existing remotes). If applicable. If
not move to Step #12.
12. Turn the ignition switch to the ON position in
order to exit.
13. Test remotes (ignition must be OFF).
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Close all doors.
2. Insert key into ignition.
3.
driver's door panel, continue to hold down until
instructed to release in Step #9.
4. Perform Steps #5 through #8 in a fairly rapid
succession.
5. Turn the ignition to the ON position (as far as you
can go without starting the engine).
6. Turn the ignition to the OFF position.
7. Release the power UNLOCK button on the door
panel. The vehicle should respond by door locks
locking and unlocking automatically.
8.
LOCK and UNLOCK buttons on
the remote until the doors lock and unlock. This
may take up to 30 seconds.
9. Repeat Step #1 now for each additional remote
(Including any existing remotes) if applicable. If
not, move to Step #10.
10. Turn the ignition to the ON position to exit the
pairing mode.
11. Test all remotes (ignition must be OFF).
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Turn ignition to ON.
2. Turn radio OFF.
PAIRING
4
UNLOCK button on the
5
3. Press Driver Information Center (DIC) RESET
button.
4. Press OPTIONS button on DIC until display is
blank.
5. Press and hold RESET button for 3 seconds.
6. Press OPTIONS button until FOB TRAINING is
displayed.
7. Press RESET button to begin pairing sequence.
8. Simultaneously press and hold LOCK and
UNLOCK
Message will appear when remote is paired.
9. Repeat this step for additional remotes.
10. Turn ignition OFF and remove keys
from ignition.
11. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Turn the ignition to RUN or ON and the radio to
off. Do not crank the engine.
2. Press and hold the DISP button on the radio for at
3. Press the SEEK up or down arrows until
FOB PROG appears on the display.
4. Press the PREV or NEXT button to enter the sub
menu. The current selection will have an asterisk
next to it. BEGIN will be displayed.
5. Press the DISP button to start pairing. When the
message PUSH FOB
LOCK and UNLOCK
at the same time for 15 seconds. A chime will be
heard to verify the remote is paired.
6. Repeat Step #5 for each additional remote up to
four remotes total. You do not need to press the
DISP button again, just press down the LOCK
and UNLOCK buttons on the next remote to be
learned to a maximum of four remotes per vehicle.
7. The mode you selected is now set. You can
either exit the PAIRING MODE by following the
instructions later in this section or pair the next
feature available on your vehicle.
8. You can exit the pairing mode by scrolling to exit
and pressing the DISP button.
9. Test all remotes (ignition must be OFF).
6
27
Advertisement
