Advertisement
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Remove the key from the ignition. Remove the
BCM PRGRM fuse from the fuse panel. Use the
legend on the fuse panel to properly locate the BCM
PRGRM fuse. Fuse panel is accessed by opening
the front passenger door.
2. Close all of the doors.
3. Close the lift-gate.
4. Insert the key into the ignition, and turn to the ACC
position.
5. Turn the key to OFF and then back to ACC within
1 second.
6. Open and close any vehicle door. A chime will
be heard when the system enters into PAIRING
MODE.
7. Press and hold the remote LOCK and UNLOCK
buttons simultaneously for 14 seconds. A chime will
be heard after successful pairing.
8. Repeat Step #7 for any other remotes.
9. Remove key from ignition.
10. Replace BCM program fuse that was removed
earlier.
11. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Insert key into the ignition switch. Turn ignition to the
RUN position (as far as you can go without cranking
engine). Wait for ignition chimes to stop.
2. Using any working remote, press the UNLOCK
button for 4 to 10 seconds.
3.
pressing the UNLOCK button and press the PANIC
button for 1 second and release both buttons at the
same time. A chime will sound within 3 seconds
to indicate that the vehicle has entered PAIRING
MODE.
4. Within 30 seconds of the chime, press and release
the LOCK and UNLOCK buttons at the same time,
then press and release the UNLOCK button on
28
PAIRING
7
8
the same remote. A chime will sound indicating the
remote has been PAIRED.
5. Repeat Step #4 for any additional remotes. Turn
ignition to OFF and remove key.
6. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Using the working remote, press LOCK button 5
times at 2 second intervals to resynchronize remote.
2. Insert key into the ignition switch. Turn ignition to the
RUN position (as far as you can go without cranking
engine). Wait for ignition chimes to stop.
3. Using the working remote, press and hold the
UNLOCK button on the remote for 4 to 10 seconds.
4.
4 to 10 seconds, continue pressing the UNLOCK
button and then press the PANIC button (on the
working paired remote) for 1 second and release
both buttons. A chime will sound to indicate that the
remote PAIRING MODE has been entered (allow 3
seconds for chime to sound).
5. Still using the working remote, within 30 seconds
of the chime, press and release the LOCK and
UNLOCK buttons simultaneously then press and
release just the UNLOCK button. A chime will sound
indicating the remote has been paired.
6. Using the new replacement remote, press
and release the LOCK and UNLOCK buttons
simultaneously and then press and release just the
UNLOCK button. A chime will sound. This remote
has now been paired.
7. For each additional new/replacement remote, press
and release the LOCK and UNLOCK buttons
simultaneously and then press and release the
UNLOCK button. A chime should be heard after
each remote signaling it has been paired.
8. Turn ignition OFF and remove key.
9. Test all remotes.
9
Advertisement
