Advertisement
10
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Enter your vehicle and close all doors.
2. Fasten your seat belt (fastening the seat belt will
cancel any chiming that may confuse you during
the pairing procedure).
3. Place key into the ignition.
4. Turn the ignition to the ON position (DO NOT
START THE ENGINE).
5. Press and hold the UNLOCK button on a working
remote.
6. Continue to hold the UNLOCK button, wait at
least 4 seconds, but no longer than 10 seconds,
then press and hold PANIC button.
7. When a single chime is heard, release both
buttons. The chime indicates the system is in
PAIRING MODE.
8. Press and release both the LOCK and UNLOCK
button simultaneously on the remote to be paired.
9. A single chime will be heard. The chime indicates
the remote was recognized.
10. Within 4 seconds of hearing the chime, press and
release any button on the remote being paired. A
single chime will be heard. The chime indicates
the remote has been paired.
11. Repeat Steps #8 to #11 for a total of 4 remotes.
12. Turn the ignition to the OFF position or wait 60
seconds to exit PAIRING MODE.
13. Test all remotes.
11
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Close and lock all doors with the driver's side
power LOCK/UNLOCK switch.
2. Insert key into ignition and remove it from the
ignition key cylinder at least 6 times within 10
performed this step successfully.
NOTE: Withdraw key completely from
ignition cylinder each time. If
PAIRING
3. Insert key into the ignition cylinder and turn to
the ACC position. Within 5 seconds, push ANY
button on the remote. Your hazard lamps should
NOTE: Do not press the button more
4. If there are any remaining remotes (including old
ones), unlock then lock all doors using the driver's
side power LOCK/UNLOCK switch and within 5
seconds, push ANY button on the next remote.
5. Repeat Step #4 for each remote (including any
existing remotes).
6. Turn the key to the OFF position, remove keys
from the ignition, unlock doors using the driver's
side power LOCK/ UNLOCK switch and open the
driver side door.
7. Test all remotes.
NOTE: Ensure any existing remotes are present when
pairing to vehicle.
1. Start with the key out of the ignition, driver's door
is open, and all others are closed and the driver's
door is UNLOCKED.
2. Perform these steps within 5 seconds.
A. Insert the key into the ignition
(Do NOT Turn). Pull key out.
B. Insert the key into the ignition
(Do NOT Turn). Pull key out.
3. Perform these steps within 40 seconds.
A. Close then open the driver's door.
B. Close then open the driver's door.
C. Insert the key into the ignition
(Do NOT Turn). Pull key out.
4. Perform these steps within 40 seconds.
this procedure is performed too
fast, system will not enter
PAIRING MODE.
than one time in the above
step. If the button is pressed
more than one time, the pairing
procedure will not be successful.
12
29
Advertisement
