Installation; Electrical Connection; Waste Water Connection - Bosch Dishwasher Instructions For Use Manual

Installation

In order to function correctly the
dishwasher must be properly installed.
Specifications for the water intake and
waste-water drainage, as well as electrical
connections, must fulfil the criteria that are
set out in the following paragraphs and the
installation instructions.
When installing the dishwasher, carry out
tasks in the following order:
– check contents of delivery upon receipt,
– site dishwasher,
– connect drainage hose,
– connect inlet hose to water supply,
– connect dishwasher to electricity supply.
Checking contents of delivery
All functions of your dishwasher have
been thoroughly tested in the factory. A
small number of water marks have been
left on the dishwasher as a result. They
disappear as soon as the appliance is
used for the first time.
Siting the dishwasher
Dimensions associated with siting the
dishwasher are contained in the
installation instructions. Ensure that the
appliance is completely level by adjusting
the feet. Make sure that it is standing on a
firm surface.

Waste water connection

See the installation instructions for the
required connection steps. If required,
attach a siphon with drainage spigot.
Using the enclosed parts, connect the
waste water hose to the drainage spigot
of the siphon.
Ensure that the drainage hose is not
kinked, crushed or twisted (ensure that
there is no sealing cover which prevents
the waster water from flowing away!).
Fresh-water connection
Using the enclosed parts, connect the
fresh water connection to the tap
according to the installation instructions.
Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always
connect a new water supply hose to the
water supply. The old supply hose must
not be re-used.
Water pressure:
Minimum 0,5 bar – maximum 10 bar. If the
water pressure is higher, install a pressure
reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water. If
you do use hot water, the temperature
should not exceed 60 ∞C.

Electrical connection

This appliance should only be connected
to a 230/240 V AC source via a properly
installed earthed socket. See nameplate
32 for size of required fuse.
The socket must be installed close to the
dishwasher.
If you need to extend the mains
connecting lead, do not cut off the plug.
Replace the whole cable, which can be
disconnected at the junction box on the
rear of the appliance.
If the domestic wiring includes a residual-
current-operated (FI) circuit-breaker, make
sure that it bears the
this type conforms to the latest regulations
Disconnecting the
dishwasher
Here too, it is important that tasks are
carried out in the correct sequence: always
unplug the appliance from the mains
electricity first of all. Pull plug out of wall
socket. Turn off water supply. Disconnect
drain and water input hoses. Remove
screws in underside of work surface.
Detach base board, if fitted. Pull out
appliance and carefully withdraw hoses at
same time.
en
mark, as only
71