Hyundai DTB 656 DW7 Instruction Manual page 69

Drain hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into
the sink, making sure to avoid bending or crimping it. Use the special plastic support that comes
with the appliance. The free end of the hose must be at a height max. 750 mm and must not be
immersed in water.
how to Drain Excess water From hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excesswater from hoses into a bowl or suitable
container that is held outside and lower than the sink.
water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avo id water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension hose
If you need a drain hose extension, observe to use a simil ar dr ain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishw asher could be
reduced.
Syphon Connection
The waste connection must be at a height of max. 75 cm
from the bottom of the dish. The w ater drain hose should be fixed by a hose clip.
Start of dishwasher
The followings should be checked before starting the dishwasher.
1) Whether the dishwasher is level and fixed
) Whether the inlet valve is opened
3) Whether there is leakage at the connections of the conducts
4) Whether the wires are tightly connected
5) Whether the power is switched on
6) Whether the inlet and drain hoses are knotted
7) All packing materials and printings should be taken out from the dishwasher
ATTENTION
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
EN - 69
EN