Picture Id Settings - LG 42LT55A Owner's Manual

52
CUSTOMIZING SETTINGS

Picture ID Settings

Picture ID is used to change the settings of a
specific display using a single IR receiver for
multi-vision. Communication is possible between
a monitor with an IR receiver and other monitors
using RS232C cables. Each monitor is identified
by a Set ID. If you assign the Picture ID using
AUDIO
the remote control, only displays with the same
(RGB/DVI)
RS-232C OUT
Picture ID and Set ID can be controlled remotely.
RS-232C IN
REMOTE
CONTROL IN
1
Assign the Set ID to the installed monitors as
shown below:
IR Receiver
RS232C cable
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
2
Press the ON (Red) button on the remote con-
trol to assign the PICTURE ID.
3
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
Picture ID
Off
Close
If you press the left/right buttons or the red ON
button for PICTURE ID repeatedly, the Picture
ID toggles between OFF and 1 to 4. Assign the
Set ID as you like.
Picture ID
◄ Off
Close
A set with a different Set ID than the Picture
y
ID cannot be controlled by IR signals.
Please refer to the Installation Manual for
y
more information on the assigning Total Set
ID.
NOTE
If Picture ID is set to 2, the upper right
y
monitor, that has a Set ID of 2, can be
controlled by IR signals.
If you press the green OFF button for
y
PICTURE ID, the Picture IDs for all monitors
are turned off. If you then press any button
on the remote control, all monitors can be
controlled by IR signals regardless of Set ID.
The Picture ID function may not work while
y
MY MEDIA is operating.
►