Operation; Remote Control Operation - Carrier Air Conditioner Owner's Manual

Handle the controller with care and avoid getting the con-
troller wet. Damage to the device may result.
IMPORTANT: The remote control can operate the unit
from a distance of up to 16 ft as long as there are not any
obstructions.
The remote control can perform the following functions:
• Turn the system ON and OFF
• Select operating mode
• Adjust room air temperature set point and fan speed
• Set time periods for automatic system operation
BATTERY INSTALLATION — Two AAA 1.5-v alkaline
batteries (included) are required for operation of the remote
control. See Fig. 3 for battery location.
After new batteries have been inserted, press the reset
button with a paper clip or the tip of a pen. Do not use old
batteries or batteries of different types, as this may cause the
Fig. 3 — Location of Batteries on Remote Control
Fig. 2 — High Wall Fan Coil Unit and Remote Control
unit to malfunction. Batteries should only be changed after
turning the unit off. The average battery life during normal
use is approximately one year. If the air conditioner does not
operate normally after replacing the batteries, refit the batteries
and press the reset button again after 5 seconds.
To install batteries:
1. Remove battery compartment cover by pushing the tab
up and removing it from the remote.
2. Insert batteries being sure to follow polarity markings
inside battery compartment.
3. Replace battery compartment cover.
NOTE: Replace batteries whenever "Low battery" indicator
appears on remote control display panel. See Fig. 4.
DISPLAY SCREEN — There are five operating mode indica-
tors that appear on the remote control display screen. See Fig. 4.
Remote Control Operation —
has 3 buttons (see Fig. 5) used for operating and controlling the
system:
• — changes operating mode
• — adjust temperature
• — turns the system on or off.
NOTE: When transmitting a command from the remote
control to the unit, be sure to point the controller toward the
right side of the unit. See Fig. 6. The unit will confirm receipt
of a command by sounding an audible beep.
IMPORTANT: If no changes are made within 10 sec-
onds, the remote control will return to its previous
setting.
3

OPERATION

The remote control