Vertical Cradle Mount; Radio Communications; Configuring The Scanner - Symbol LS4278 Product Reference Manual

Vertical Cradle Mount

When mounting the cradle vertically:
1. Ensure the rubber feet are attached to the cradle. These feet provide traction and prevent surface damage.
2. Ensure the convertible mount hook on the front of the cradle is inserted with the hook facing up. If not, remove and reverse
the hook so that it is in position to secure the scanner in place. (See
mount hook.)
3. Ensure the desk/wall mount converter knob is in the position shown in
Desk/Wall Mount
Converter Knob
Figure 1-9. Vertical Mount - Inserting the Scanner in the Cradle
For your convenience, a wall mount bracket can be purchased from Symbol Technologies. For the appropriate
measurements, and instructions on mounting the cradle, refer to the STB4208/4278 Quick Reference Guide
(p/n 72-71010-xx).

Radio Communications

The scanner can communicate with remote devices via Bluetooth Technology Profile Support, or by pairing with a cradle. For radio
communication parameters, detailed information about operational modes, Bluetooth Technology Profile Support and pairing, see
Chapter 4, Radio Communications.

Configuring the Scanner

Use the bar codes in this manual or the 123Scan configuration program to configure the scanner. See
each host chapter for information about programming the scanner using bar code menus. See
scanner using this configuration program. 123Scan includes a help file.
Figure 1-3 on page 1-6 for the location of the convertible
Figure 1-9.
Chapter 4, User Preferences
Chapter 11, 123Scan
Getting Started 1-13
and
to configure the