Adjusting The Clock - Yamaha MCR-840 Owner's Manual

Adjusting the Clock

Before starting playback operation, follow the procedure
below to adjust the clock setting of the receiver.
Notes
• Use the remote control to set the clock. You cannot set the clock
with the buttons on the receiver.
• The receiver supports 24-hour clock display.
• If you do not touch any key for 90 seconds, the receiver returns
to normal mode.
TIMER
ENTER
1
Press to turn the receiver on.
The front panel display lights up.
2
Press TIMER to show the current time.
If the clock is not set, "SET TIME" flashes on the
display.
Press ENTER to proceed to step 3.
3
Press / to select "TIME", and press
ENTER.
The receiver enters clock setting mode. The hour
digits start flashing.
,
RETURN
Flashes
4
Set the hour using
The minute digits start flashing.
5
Set the minutes using
ENTER.
The hour and minute digits start flashing.
To change the hour or minutes again, press
do steps 4 and 5, and proceed to step 6.
6
Press ENTER.
The clock is set.
The hour and minute segments stop flashing and
remain on. The receiver returns to normal mode.
y
You can return to the previous screen by pressing
RETURN.
PREPARATIONS
/ , and press .
Flashes
/ , and press
or ,
Flashes
or
13
En