Constant Velocity Driveline Angle; Pre-Operation Instructions - Land Pride AFM4211 Operator's Manual

Land Pride
Section 2: Operating Instructions

Constant Velocity Driveline Angle

Refer to Figure 2-3:
The main driveline is equipped with a constant velocity
(CV) joint that allows the unit to run at angles up to
80 degrees with no vibration.
19626
Constant Velocity Driveline Angle
Figure 2-3
IMPORTANT: Do not make turns that will subject
the CV joint to angles greater than 80
o
greater than 80 will damage the driveline.
The constant velocity joint must be greased every 8
hours of operation. Refer to Page 28 "Driveline
Constant Velocity Shaft".

Pre-Operation Instructions

Proper servicing and adjustments are key to the long life
of any machine. With careful and systematic inspection
of the mower, you can avoid costly maintenance, time
and repair. Before beginning to mow, the following
inspection should be performed:
!
CAUTION
Before unfolding the mower make sure the transport locks are
unlatched. Unlatch locks by pulling the rope.
•
Grease driveline shaft and all other grease fittings.
•
Check oil level in gearboxes. Refer to the Lubrication
portion of the "Maintenance and Lubrication"
section starting on page 28.
•
Check all plugs and caps in gearboxes to make certain
that they have been replaced and tightened properly.
•
Check mower blades for damage and sharpness. See
"Blade Inspection" on page 23.
•
Be sure blades are installed properly on each deck with
the cutting edge leading in rotation. See "Blade
Removal And Installation" on page 24.
4/12/11
Table of Contents
•
Be sure all mower blades bolts are tight. Know which
center blade bolts are left hand threaded and which are
right hand threaded when checking for tightness. See
"Blade Removal And Installation" on page 24.
•
Be sure all bolts and nuts are tight.
•
Be certain all guards and shields are in place and
secure.
•
Clear the area to be mowed of objects and debris that
might be picked up and thrown by the mower blades
•
Operate with 540 rpm PTO tractor.
•
Refer to your tractor's operator manual for engaging
and disengaging the PTO.
•
In case of emergency learn to stop tractor and mower
quickly.
•
Complete Operating Checklist below before
continuing.
4
o
. Angles
Operating Checklist
Check
Safety Rules
Gearbox Gear Lube
Tractor Hook-up
Tire Inflation Chart
Lubricate the mower as needed.
Check the mower initially and
periodically for loose bolts & pins.
Make sure the hitch safety chain is
securely attached to the mower hitch
and the tractor.
Inspect the blades. Make note of the
wear to the blades and the sharpness
of the blades.
Make a thorough examination of the
driveline. Also check the connection to
the gearboxes and tractor PTO.
Make sure all guards and shields are
in place.
AFM4211 All Flex Grooming Mower 315-507M
Referenc
Page 1
Page 23
Page 12
Page 37
Page 23
Page 12
Page 23
17