Table of Contents
Advertisement
Section 1: Assembly & Set-up
Category III 3-Point Hitch
Category II Quick Hitch
Category II 3-Point Hitch
Hitch Pin Configuration (Based on Hitch Category)
Figure 1-3
7.
Adjust top center link in or out to align center link hole
with the cutter's center hitch pin hole. Connect top
center link to cutter hitch pin hole using customer
supplied clevis pin and linchpin.
8. Make certain the lower 3-point arms are stabilized to
prevent excessive side movement.
9. Return to tractor and slowly raise tractor 3-point hitch
1 to 2 inches. Stow jack stands in the raised position.
10. Slowly operate tractor's 3-point arms up and down to
check clearance between cutter components and
tractor components. Move or remove tractor drawbar
if it interferes with cutter.
11. Adjust tractor's lower lift arms to level cutter from left
to right.
12. Adjust center top-link to level cutter from front to rear.
13. Final deck leveling adjustments will be made later.
11/2/18
Table of Contents
37298
Driveline Installation
!
DANGER
To avoid serious injury or death:
•
Do not engage power take-off while hooking-up or
unhooking the driveline, or while someone is standing near
the driveline. A person's body and/or clothing can become
entangled in the driveline.
24642
All guards and shields must be installed and in good
•
working condition while operating the implement.
Do not use a power take-off adapter. The adapter will
•
increase strain on the tractor's power take-off shaft causing
possible damage to shaft and driveline. It will also defeat
the purpose of the tractor's power take-off shield.
!
WARNING
To avoid serious injury or death:
Always shut tractor down using "Tractor Shutdown
Procedure" provided in this manual before dismounting
tractor.
!
CAUTION
To avoid minor or moderate injury:
Some tractors are equipped with two power take-off speeds.
Be certain your tractor's power take-off is set at the
implement's rated power take-off speed or equipment
breakage may result. RC models are rated for 540 rpm and
RCM models are rated for 1000 rpm.
IMPORTANT: Do not engage tractor PTO until
driveline is fully connected and hydraulic fluid has
been added to the cutter reservoir.
IMPORTANT: An additional driveline may be
required if implement is attached to more than one
tractor or if a Quick Hitch is used.
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
Tractor 3-Point Hitch
Figure 1-4
15
Advertisement
Table of Contents
