Sp Board; S Board - Sony FWD-50PX1 Service Manual

1-3-3. SP Board

1. Remove the rear cover assembly.
(Refer to Section 1-2-1.)
2. Remove the harness from the SP board.
3. Remove the two screws, then remove the SP board.
Harness
SP board
4. Install the SP board in the reverse order of steps 1 to 3.
1-6

1-3-4. S Board

n
The three S boards are installed in this unit. When
replacing them, remove/install in the same procedure.
1. Remove the rear cover assembly.
(Refer to Section 1-2-1.)
2. Disconnect the harness from the S board.
3. Remove the screw, then remove the S board.
BVTP
3 x 8
Harness
Conductive cushion
Harness
4. Install the S board in the reverse order of steps 1 to 3.
PSW
PSW
3 x 6
3 x 6
S board
PSW
3 x 6
S board
Harness
S board
FWD-50PX1