H3 Board; Sp Board - Sony FWD-32LX1R Service Manual

1-4-8. H3 Board

Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the screw, then remove the light pipe and H3
board.
3. Disconnect the harness from the connector (CN9300)
on the H3 board.
Conductive cushion
Installation
4. Install the light pipe and H3 board in the reverse order
of steps 2 and 3.
n
When attaching the cabinet assembly, be careful not to
catch the cord.
5. Reattach the cabinet assembly.
(Refer to Section 1-3-1.)
1-10
Harness
BVTP
3 x 12
CN9300
Light pipe
H3 board
H3 board

1-4-9. SP Board

Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the shield cover G and two arms.
(Refer to steps 2 and 3 of Section 1-4.)
3. Disconnect the harness from the connector (CN9500)
on the SP board.
4. Remove the two screws, then remove the SP board.
Harness
SP board
Installation
5. Install the SP board in the reverse order of steps 3 and
4.
6. Reassemble this unit in the reverse order of steps 1 and
2.
BVTP
3 x 12
(Black)
FWD-32LX1R