Plasma Display Panel - Sony FWD-50PX1 Service Manual

1-4-3. Plasma Display Panel

n
Be sure to replace the plasma display panel with two persons.
1. Remove the rear cover assembly. (Refer to Section 1-2-1.)
2. Remove the bezel assembly. (Refer to Section 1-2-2.)
3. Remove the QB block assembly. (Refer to Section 1-4-1.)
4. Remove the S board. (Refer to Section 1-3-4.)
5. Remove the Y drive board. (Refer to Section 1-3-5.)
6. Remove the X drive board. (Refer to Section 1-3-6.)
7. Remove the digital video board and interface board. (Refer to Section 1-3-7.)
8. Remove the power unit. (Refer to 1-4-1.)
9. Remove the cushions (15x25) attached to the heads of the three bolts on the right side as viewed
from backside.
10. Remove the five bolts (M8 x 16), then remove the two main brackets.
11. Remove the four screws (PSW3 x 8), then remove the two frames (H).
12. Remove the six screws (PSW3 x 8), then remove the two side frames.
PSW3 x 6
Frame (H)
PSW3 x 6
Side frame
Plasma display panel
13. Attach the plasma display panel in the reverse order of steps 1 to 12.
FWD-50PX1
Main brackets
M8 x 16
Conductive cushion
Cushion
(15x25)
M8 x 16
(Right side as viewed from backside)
Side frame
PSW3 x 6
PSW
3 x 6
Frame (H)
1-11