Table of Contents
Advertisement
Section 5: Maintenance & Lubrication
SC2660 Spindle Hub Lubrication
Do Not Overfill
IMPORTANT: Your cutter is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
4/24/12
Table of Contents
Motor Spindle Hub (SC2660 Only)
The motor spindle hub (#1), has two cavity plugs (#2)
located on the hitch side of the hub housing.
1. Disengage blade hydraulics. Make sure blades have
come to a complete stop.
2. Disconnect float chains from cutter deck at mounting
holes "A" (See Figure 2-3 on page 16).
3. Disconnect height adjustment safety chain from front of
loader (See Figure 2-3 on page 16).
4. Raise front of cutter off the ground and tilt hitch forward
25838
until cutter is hanging from the hitch straight down.
5. Set park brake, shut engine off, and remove switch key
before continuing.
6. Remove one of the cavity plugs (#2) to check fluid level.
Fluid level should be within 1/2" from top of port
opening.
7. Add EP 80-90 weight gearlube as required. Full
capacity of motor housing is approximately 1/3 pint.
8. Install cavity plug and tighten.
9. Being careful not to damage the tail wheel, lower cutter
back to ground level.
10. Reattach adjustment safety chain and float chains.
30215
Gearbox (SC2672 Only)
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore, always
check oil level when cold.
Method 1: Unscrew top vented dipstick (#1). Wipe oil from
dipstick and screw dipstick in without tightening. Unscrew
dipstick and check oil on dipstick. If below bottom level
mark, add recommended gear lube through dipstick hole
until oil reaches top mark on dipstick. Reinstall vented
dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below bottom
of plug hole, add recommended gear lube through top
dipstick hole until oil flows out of side plug hole. Reinstall
and tighten side oil plug (#2) and vented dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flows out side plug hole in gearbox.
SC2660 & SC2672 Skid Steer Rotary Cutter 326-025M
8
Hrs.
8
Hrs.
27
Advertisement
Table of Contents
