Table of Contents
Advertisement
Section 1: Assembly & Set-up
Skid Shoe Assembly (Optional)
Refer to Figure 1-7:
Cutters ordered with skid shoes are shipped loose.
Install skid shoes as follows:
1. Raise the Rotary Cutter 3" or more off the ground
and place support blocks under the cutter. Make sure
support blocks are positioned so they will not
interfere with skid shoe installation.
2. Lower cutter onto support blocks, place Skid Steer in
park, set park brakes, shut Skid Steer off, and
remove switch key.
3. Install short skid shoe (#2) to the back left deck
corner as shown with 3/8"
(#2), flat washers (#6), lock washers (#5), and 3/8"
lock nuts (#4). Torque lock nuts (#4) to 31 ft-lbs.
4. Install long skid shoes (#1) to the remaining three
deck corners with 3/8"
flat washers (#6), lock washers (#5), and 3/8" lock
nuts (#4). Torque lock nuts (#4) to 31 ft. lbs.
5. Raise cutter up and remove support blocks.
Operator Protective Door (Optional)
Refer to Figure 1-8:
!
WARNING
Do not drill holes in the ROPS (Roll Over Protection System)
to attach this Operator Protective Door. Drilling unapproved
holes in the ROPS can weaken the structure and void its
warranty.
Instructions below are for installing land Pride's optional
Operator Protective Door. See your Skid Steer/Tractor
Operator's Manual for installation instructions of their
Operator Protective Door.
1. Cut notches in protective door as needed to provide
clearance around u-bolts and Skid Steer frame.
2. Install Operator Protective Door to the Skid Steer's
hand hold with two u-bolts (#3), flat bars (#2), and
four nuts (#1) as shown. Tighten nuts to correct
torque.
4/24/12
Table of Contents
plow bolts
-16 x 1 1/4" GR5
plow bolts (#2),
-16X1 1/4" GR5
24546
Skid Shoe Replacement
Figure 1-7
If needed, Locate & Cut
Notches in Door For
U-bolts Clearance.
Skid Steer
Hand Hold
Operator Protective Door
Figure 1-8
SC2660 & SC2672 Skid Steer Rotary Cutter 326-025M
Hook Elastic Tie-Down
To Skid Steer Cage To
Keep Door Closed.
If Needed, Locate
& Cut Notch in
Door To Clear Skid
Steer Frame.
24608
13
Advertisement
Table of Contents
